Analysis and Research of the Vibration of the High-Speed Cutting Process


Article Preview

The paper takes the dynamic cutting process as research subject to analyze and research the high-speed milling process. Through carrying out the dynamical modeling and simulation of the milling process, the analytical model of the dynamic cutting force and the chatter stable region of the spiral end mill were established. On the basis of the analytical model, the simulation of the end milling process was carried out, and the interpretational domain of the simulation was confirmed experimentally. Finally, the parameter optimization of the high-speed cutting process was investigated in the term of the stability of the cutting process.



Main Theme:

Edited by:

Chengyong Wang, Ning He, Ming Chen and Chuanzhen Huang




A.M. Tang et al., "Analysis and Research of the Vibration of the High-Speed Cutting Process", Advanced Materials Research, Vol. 188, pp. 642-647, 2011

Online since:

March 2011




[1] Dewes R.C. and Aspinwall D.K. A review of ultra high speed milling of hardened steels[J]. Journal of material processing technology, 1997, 69(1-3).


[2] Li H.Z. and Yu X.H. Computer simulation of cutting vibration in face milling [J]. Journal of Vibration Engineering, (2001).

[4] Elbestawi M.A., Ismail F. and Du R. et al. Modeling Machining Dynamics Including Damping in the Tool-Workpiece Interface[J]. Journal of Engineering for Industry, 1994, 116(4).


[5] Budak E., Altintas Y. and Armarego E.J.A. Prediction of milling force coefficients from orthogonal cutting data[J]. Transactions of the ASME Journal of Manufacturing Science and Engineering, (1996).


[6] Minis I. and Yanushevsky R. Analysis of linear and nonlinear chatter in milling[C]. Annals of the CIRP, 1990, 39.


[7] Li Z.Q. Dynamic Modeling, Simulation and Optimization of High Speed Milling under Complicated Cutting Conditions[D]. Beijing University of Aeronautics and Astronautics, (2008).

Fetching data from Crossref.
This may take some time to load.