Research on Defects of Titanium Alloy Laser Rapid Forming


Article Preview

In the process of metal powder laser rapid forming, various defects may be caused in forming parts on account of technical parameters, equipment performance, material characteristics and other factors. While dimensional accuracy error and surface sticky powder caused by powder factor are the two major defects of forming parts. The experimental analysis finds that less or over accumulation resulting from powder feed delay is the main reason for affecting the dimensional accuracy of cladding and the main reason which affects the appearance of surface sticky powder is specific energy.



Advanced Materials Research (Volumes 189-193)

Edited by:

Zhengyi Jiang, Shanqing Li, Jianmin Zeng, Xiaoping Liao and Daoguo Yang




X. F. Shang et al., "Research on Defects of Titanium Alloy Laser Rapid Forming", Advanced Materials Research, Vols. 189-193, pp. 3726-3730, 2011

Online since:

February 2011




[1] Information on http: /baike. baidu. com/view/64612. htm.

[2] R.L. Sun: Microstructure and Wear Properties of Laser Clad Ni-TiC Composite Coating on Titanium Alloy Substrate (Ph.D., Harbin Institute of Technology, China 2000), pp.20-28. In Chinese.

[3] L. Chu, J. Chen and X. Lin. Rare Metal Materials and Engineering. Vol. 36 (2007) No. 4, pp.612-616.

[4] H.M. Wang, L.Y. Zhang and A. Li. Technical Research and Development of the World. Vol. 26 (2004) No. 3, pp.27-31.

[5] S. Yang, M.L. Zhong and Q.M. Zhang: PowderMetallurgy Technology, Vol. 20 (2002) No. 4, pp.234-238.

[6] X.F. Shang: Research on Metal Powder Laser Shaping(Ph.D., Shenyang Institute of Automation Chinese Academy of Sciences, China 2005), pp.30-35.