Microstructure and Properties and Wear Resistant of Carbide Free Bainitic Casting Steel


Article Preview

The microstructure and properties and wear resistant of carbide free bainitic casting steel were studied by using of OM, TEM, XRD, impact test and abrasion test. The results showed that after normalizing at 1080°C and tempering at low temperature the microstructures consisted of bainitic ferrite, remaining austenite and no carbides with combination properties of strength and toughness. After tempering at 250°C the tensile strength was 1667MPa, Rockwell hardness HRC49 and impact ductility AKU 36J, respectively. This new casting steel by normalizing at 1080°Cand tempering at 200°C had better wear resistance than that of high manganese steel under the same test conditions, moreover the reason was analyzed.



Advanced Materials Research (Volumes 287-290)

Edited by:

Jinglong Bu, Pengcheng Wang, Liqun Ai, Xiaoming Sang, Yungang Li






Z. X. Liu and J. Q. Cheng, "Microstructure and Properties and Wear Resistant of Carbide Free Bainitic Casting Steel", Advanced Materials Research, Vols. 287-290, pp. 1056-1060, 2011

Online since:

July 2011




[1] Wei Li. Journal of Foundry, 53 (2004), p.958. (in Chinese).

[2] Hongfa Wang. Journal of Foundry, supplement (2000) , p.577. (in Chinese).

[3] Mokuang Kang, Ming Zhu, Daming Chen etc. Heat Treatment of Metals, 30(2005), p.14. (in Chinese).

[4] Hongsheng Fang, Dongyu Liu, Bing2zhe Bai etc. Heat Treatment of Metals, 26(2001) , p.4~6. (in Chinese).

[5] Mokuang Kang, Ming Zhu. Acta Metallrugica Sinica, 41(2005), p.673.

[6] Ping Wang, Zheng Yang, Mokuang Kang etc. Northwestern Polytechnical University Journal, supplement (1990) , p.101. (in Chinese).

[7] Bhadeshia H K D H, Edmonds D V. Metall Trans. 10A(1979) , p.895.

In order to see related information, you need to Login.