Based on the ANSYS Software to Research Lasers Coating Applied with the Ho-Type Cutting Pick


Article Preview

Based on the ANSYS Software the Ho-type cutting pick of Spiral Drum Shearer applied lasers coating is feasible analysis. At first the paper describes the Spiral Drum Shearer’s overall body and elicit to its traditional materials. Then analysis the head of Cutting pick’s traditional materials in order to apply with lasers coating. Then simulate it and Fatigue calculation by ANSYS Software. By analysis of the coating pick is found that the Cutting pick’s life can develop well. So it has a nice economic Potential.



Advanced Materials Research (Volumes 308-310)

Edited by:

Jian Gao




N. N. Xu et al., "Based on the ANSYS Software to Research Lasers Coating Applied with the Ho-Type Cutting Pick", Advanced Materials Research, Vols. 308-310, pp. 2349-2352, 2011

Online since:

August 2011




[1] W.F. Xu: Mining Safety and Environmental Protection, Vol. 12 (2009) No. 3, p.100 (In Chinese).

[2] J. Mu and Z.B. Li: Coal Mine Machinery, Vol. 01 (2000) No. 24 p.98 (In Chinese).

[3] J.Z. Bai: LS2DYNA3D Theory and Case Analysis. (Science Press, Peking 2005) p.250(In Chinese).

[4] C.S. Liu: Coal, Vol. 01 (2004) No 29, P115 (In Chinese).

[5] X.J. Shang, S.J. Yu and H.F. Wang: ANSYSöLS2DYNA dynamic analysis methods and engineering example. (Water Power Press, Beijing 2006) p.126 (In Chinese).

[6] W. Guo, T.C. Zhao and N.B. Ma: Liao-ning Chemical Industry, Vol. 36 (2007), No1, pp.16-19(In Chinese).

[7] Y Wu and Y. Niu. Materials Protection, Vol. 38 (2005), No. 2, p.61(In Chinese).

[8] S. Zimmermann, H. Keller and G. Schwier: Advancing the Science Applying the Technology. (Asm International of Materials Park, Ohio, USA 2003) p.227.

[9] D. Raghu and Y.C. Wu: Mater Perform, Vol. 01 (2007) p.36.

[10] M. J . Tobar, C. Alvarez and J.M. Amador. Surface Coatings Technology, Vol. 23 (2006), No. 2 p.6313.

Fetching data from Crossref.
This may take some time to load.