On Deformation of the Injection Mold Core

Abstract:

Article Preview

For injection mold with core, during the injection molding process, the pressure on the core is usually uneven and will cause the core to deform. In this paper, on the basis of some predigestions and assumptions of the model, formulas for forecasting the deformation of the circular cross-section and the rectangular cross-section cores under three different injection ways are analyzed. The theoretical analysis results of a core with special section are validated through finite element software. At the end, some suggestions are given to minish the core deformation when the calculation value is too large.

Info:

Periodical:

Advanced Materials Research (Volumes 44-46)

Edited by:

Z.Y. Shen, M.N. James, W.D. Li, and Y.X. Zhao

Pages:

85-89

DOI:

10.4028/www.scientific.net/AMR.44-46.85

Citation:

J.J. Jia et al., "On Deformation of the Injection Mold Core", Advanced Materials Research, Vols. 44-46, pp. 85-89, 2008

Online since:

June 2008

Export:

Price:

$35.00

In order to see related information, you need to Login.