An Accurate Calculation of the Elongation of Strip in Tension Leveling Process


Article Preview

In the tension leveling process, calculation of the strip elongation by the traditional method only considers the extension rate after the tension response, while ignoring elastic bending recovered, so the calculation of elongation is large enough to affect the process control accuracy. This paper considers not only the residual strain after elastic bend recovery, but also the affection of the residual deformation under plain cross-section assumption. The calculation of the elongation is less 4-10% than that of the traditional one. It shows that parameters of the tension leveling process set by the new method will be calculated accurately.



Advanced Materials Research (Volumes 472-475)

Edited by:

Wenzhe Chen, Xipeng Xu, Pinqiang Dai, Yonglu Chen and Zhengyi Jiang




P. J. Zhao et al., "An Accurate Calculation of the Elongation of Strip in Tension Leveling Process", Advanced Materials Research, Vols. 472-475, pp. 813-816, 2012

Online since:

February 2012




[1] Jiaxiang Zou: Rolling Machine, Metallurgical Industry Press(2005), pp.393-395, In Chinese.

[2] Fu Cui: Levelling Principle and Levelling Machine, Metallurgical Industry Press(2004), pp.382-390, In Chinese.

[3] Jingwei Yi, Qihong Dai, Lixing Wu: Cfhi Technology(2003), In Chinese.

[4] Shuhua Li, Tongqing Li: Shanghai Metals(2001), In Chinese.

[5] Martin G. Kinnavy: Iron and steel engineer(1990).

[6] Yukio Kimura, Masayasu Ueno, Yasuhiro sodani: 44th mwsp conference proceeding vol xl(2002).

[7] Qisen Liu: Heavy Machinery(1982), In Chinese.