Image Based Analysis Evaluation of the Elements of Secondary Adhesion Wear in Dry Turning of Aluminum Alloys


Article Preview

Minimizing downtime in machine tools is one of the factors that determine the performance increase of the production processes involved. This increase can be considered from different points of view: economic, energetic and environmental. Machining processes can be stopped by needing to change the tool as a consequence of the loss of their initial properties due to the wear process that suffer during machining. One of the wear processes which takes place in a wider range of temperatures in the machining of metal alloys is the adhesion wear, and specially in the case of light alloys, secondary adhesion wear, which can be placed in the tool rake face as a layer (Built-Up Layer, BUL) and in the tool edge (Built-Up Edge, BUE). This paper analyzes the influence of cutting parameters on the secondary adhesion wear effects in the dry turning of UNS A92024 (Al-Cu) alloy.



Edited by:

M. Marcos and J. Salguero




M. Batista et al., "Image Based Analysis Evaluation of the Elements of Secondary Adhesion Wear in Dry Turning of Aluminum Alloys", Advanced Materials Research, Vol. 498, pp. 133-138, 2012

Online since:

April 2012




[1] J.P. Womack and T. Daniel: Lean Thinking: Banish Waste and Create Wealth in Your Corporation, (Harper Business, 2003).

[2] E.M. Trent: Metal Cutting (Butterworths, London 1989).

[3] G. Boothroyd and W.A. Knight: Fundamentals of Machining and Machine Tools (Marcel Dekker, New York 1989).

[4] K. Ohgo: Wear Vol. 51 (1978), p.117 – 126.

[5] M. Nouari, G. List, F. Girot and D. Coupard: Wear Vol. 255 (2003), p.1359–1368.

[6] M.S. Carrilero, R. Bienvenido, J.M. Sanchez, M. Alvarez, A. Gonzalez and M. Marcos: Int. J. of Mach. Tools & Manuf. Vol. 42 (2002), p.215–220.

[7] M. Marcos, M. Álvarez, M. Huerta, J. Salguero and J.A. Sánchez: Adv. in Mat. Sci. and Eng., in press, DOI: 10. 1155/2011/414868.

[8] J.M. Sánchez-Sola, M.A. Sebastián, M.S. Carrilero, J.M. González and M. Marcos: Rev. Met. Mad. Vol. 2 (2005), pp.365-368.

[9] M. Batista, J. Salguero, A. Gomez, M.S. Carrilero, M. Alvarez and M. Marcos: Adv. Mat. Res. Vol. 107 (2010), pp.141-146.

[10] J. Barreiro, M. Castejon, E. Alegre and L.K. Hernandez: Int. J. of Mac. Tools & Manuf. Vol. 48 (2008), p.1005–1013.

Fetching data from Crossref.
This may take some time to load.