Improving Corrosion Resistance of the Hot-Dip Aluminum Coating on 22MnB5 Steel Surface

Abstract:

Article Preview

Keywords: Hot-Dip Aluminum; Corrosion resistance; Fe-Al Intermetallic alloys Abstract. The hot-dipping Al coating was developed on 22MnB5 steel surface. Effects of corrosion resistance with different dipping time coatings were investigated in this paper. It is describes an approach to improve the corrosion resistance of 22MnB5 steel. The results of the polarization curves show that the dipping 2min coatings have the highest corrosion potential (Ecorr) and the lowest corrosion current (icorr), indicating that this coating is a best corrosion inhibitor. It is similar results with EIS for corrosion resistance, respectively. The proper thickness (~20µm) of Fe-Al compounds between Fe substrate and Al coatings must be selected (750°C, hot-dipping 2min) in order to improve corrosion resistance for 22MnB5 steel.

Info:

Periodical:

Advanced Materials Research (Volumes 581-582)

Edited by:

Jimmy (C.M.) Kao, Wen-Pei Sung and Ran Chen

Pages:

410-413

Citation:

C. Y. Wang et al., "Improving Corrosion Resistance of the Hot-Dip Aluminum Coating on 22MnB5 Steel Surface", Advanced Materials Research, Vols. 581-582, pp. 410-413, 2012

Online since:

October 2012

Export:

Price:

$38.00

[1] Zhao Q., Yin F.C., Zhao M. X., et al. Tran. Mater. Heat Treat., 32(2011): p.50.

[2] Sun Z., Wang W. Y., Ou X. M., J. China Univers. Min. Technol., 28(1999): p.251.

[3] Qian J. G., Zhang J. X., Li S. Q., et al. Rare Metal Mater. Engineer., 41(2012): p.360.

[4] J.R. Davis (Ed. ), Aluminum and Aluminum Alloys, ASM Specialty Handbook, ASM International, 1993, p.180.

[5] C. Wick, R.F. Veilleux (Eds. ), Mater. Finish. Coat., Soc. Manuf. Engineer., 1985, p.23.

[6] Gul Hameed Awan, Faizul Hasan. Mater. Sci. Engineer. A, 472 (2008): p.157.

[7] Li X. M., Liu B., Dong X. F. Appl. Mech. Mater, 117-119(2012): p.1121.

[8] Lu L. H., Shen D. J., Zhang J. W., et al. Appl. Surf. Sci., 257(2011): p.4144.

[9] Wang C. J., Chen S. M. Surf. Coat. Technol., 200(2006): p.6601.

[10] Li X. M., Lu P. K., Hu Q. et al. Adv. Mater. Res., 266(2011): p.246.

[11] Konys J., Krauss W., Holstein N. Fus. Engineer. Des., 85(2010): p.2141.