Characterization of Cutting Temperature and Ignition Phenomena of Magnesium Chip Using Infrared Imaging


Article Preview

In this paper, we report our experimentation about measurement temperature of ignition cuts and chip phenomenon using infrared imaging methods, to model and simulate machine rotary cutting tool system. Finally this research was obtained of the optimum conditions expected of cutting magnesium at high speed and without coolant.



Advanced Materials Research (Volumes 588-589)

Edited by:

Lawrence Lim




S.R. Sulistiyanti et al., "Characterization of Cutting Temperature and Ignition Phenomena of Magnesium Chip Using Infrared Imaging", Advanced Materials Research, Vols. 588-589, pp. 1744-1747, 2012

Online since:

November 2012




[1] K. Tonnesen, N. Tomac dan F.O. Rasch. 1992. Machining magnesium alloys with use of oil-water emulsions. 8th Int. Colloquium, Tribology (2000).

[2] S. Harun, 2009, Study on Turning with Actively Driven Rotary Tool, Doctoral Dissertation, Kobe University.

[3] Barron, W.R., 2000, Principles of Infrared Thermometry. Williamson Corporation.

[4] Christiansen, J., and Gerow G., 1990, Thermography, Williams and Wilkins. Baltimore.

[5] S. Ratna Sulistiyanti, F.X. Arinto Setyawan, and Adhi Susanto, Histogram Characterizations of Infrared Images Captured by a Modified Digital Camera, International Journal of Electronic Engineering Research (IJEER), Research India Publications (RIP), Vol. 1, No. 4, 2009, pp.329-336.

[6] Orlove, G. P.E., 2001, How to Capture a Good Thermogram, InfraMation, Volume 2, Issue 8, August, U.S. A.

[7] Pavelka, M., Janotková, E., Štetina, J. 2001, Visualization and Optics Measurement Methods, VUT Brno.

Fetching data from Crossref.
This may take some time to load.