Research on Cylinder Drop Stamping Part of Heat Recovery Regularity Based on Pro/Mechanica


Article Preview

There are large quantities of heat is wasted in the producting process of cylinder drop stamping part, it is necessary to recycle the heat from the perspective of environmental protection. In this paper the waste heat recovery system that based on heating pump were analyzed, building up cylinder drop stamping normalizing temperature curve and observed metallographic microstructure of the samples at different temperatures. Rapid establishment of geometric model through the use of Pro/Engineer, application of Pro/Mechnica analog normalizing temperature curve, observed the cross-section temperature field nephogram. Based on the analysis, been established by virtual prototype thermal analogue in the Pro/Mechnica with the measured cooling process is consistent. waste heat recovery system which is used in the production of cylinder drop stamping part is effective.



Advanced Materials Research (Volumes 588-589)

Edited by:

Lawrence Lim




L. L. Chen et al., "Research on Cylinder Drop Stamping Part of Heat Recovery Regularity Based on Pro/Mechanica", Advanced Materials Research, Vols. 588-589, pp. 1837-1841, 2012

Online since:

November 2012




[1] Chen Hui, CHEN Lili , Qin Panpan, Yu Luning, Liu Shikui. The Structure Property of Tube 58SiMn in Waste Heat Recovery System[J], Journal of shenyang jianzhu University (Natural Science), 2011, 27(5) : 981-985.


[2] CHEN Hui, CHEN Lili, QIN Panpan, YU Luning, LIU Shikui. 58SiMn waste heat recovery systems in the performance test, The 2nd International Conference on Mechanic Automation and Control Engineering. July 15-17, 2011: 1-3, Inner Mongolia, China.


[3] Pan Jun, Han Chunyang, Jiao Long, Liu Yang. Experimental study on application of composite well to groundwater source heat pump engineering [J]. Geotechnical Investigation & Surveying, 2012, (4): 34-37.

[4] ZHANG Xiaoming, WU Jiankun. The Application of Ground Source Heat Pump System and Its Economic Analysis[J], Journal of Shenyang Jianzhu University(Social Science), 2011, 13(1): 35-39.

[5] Zhang Caiying, Xu Pan, Bi Zhiyu. an air compressor waste heat recovery and utilization methods [J]. renewable energy, 2009, (05): 78-82.

[6] Liu Jiaming, Zhao Yan, Ye Jiandong. boiler steam condensate recovery and use [J]. China Water & Wastewater, 2010, (02): 83-87.

[7] Gong Wei, Wang Zhonghou, Huang Yuhua, Wang Xueying. Grinder Bed Finite Element Analysis of Thermal Deformation Based on the Pro / MECHANICA[J]. Precision Manufacturing and Automation, 2007(3): 49-50.

[8] Ju Zhilan, Hua Guoran, Chen Houjun. Thermal and MechanicalAnalysis of Piston Using 3D Finite Element Method Based on Pro/Mechanica[J]. Small Internal Combustion Engine and Motorcycle, 2010, 39(3): 9-12.