Fractography of Advanced Ceramics II

Volume 290

doi: 10.4028/www.scientific.net/KEM.290

Paper Title Page

Authors: Ivo Dlouhý, Zdeněk Chlup

Abstract: Determination of the fracture toughness using a specimens with straight and/or chevron notch in the three (four) point bend test for...

167
Authors: Gurdial Blugan, Richard Dobedoe, I. Gee, Nina Orlovskaya, Jakob Kübler

Abstract: Multi-layer laminates were produced using alternating layers of Si3N4 and Si3N4+TiN. The differences in the coefficient of thermal...

175
Authors: Marion Bartsch, Iulian Mircea, Jens Suffner, Bernd Baufeld

Abstract: The basic requirement for the use of a ceramic coating is sufficient adhesion to its substrate. A measure of the adhesive properties of a...

183
Authors: Raúl Bermejo, Luis Llanes, Marc Anglada, Peter Supancic, Tanja Lube

Abstract: In this work, the thermal shock behavior of an Al2O3-5%tZrO2/Al2O3-30%mZrO2 multilayer ceramic is studied. On these materials, a tetragonal...

191
Authors: Carmen Baudín, Ali Sayir, Marie Helene Berger

Abstract: The mechanical properties of directionally solidified two-phase eutectics can be superior to that of either constituent alone due to the...

199
Authors: Jonas Gurauskis, Javier Pascual, Tanja Lube, Antonio Javier Sanchez-Herencia, Carmen Baudín

Abstract: A lamination technique for joining ceramic green tapes fabricated from aqueous ceramic slurries via tape casting process is investigated....

203
Authors: S. Bueno, Carmen Baudín

Abstract: Alumina (Al2O3)-aluminium titanate (Al2TiO5) composites present higher toughness than alumina materials but rather low strength due to...

208
Authors: Javier Pascual, Francis Chalvet, Tanja Lube, Goffredo de Portu

Abstract: In order to better understand the fracture behavior of Al2O3-Al2O3/ZrO2 laminates, controlled crack growth experiments were carried out....

214
Authors: Luca Ceseracciu, Francis Chalvet, Emilio Jiménez-Piqué, Marc Anglada, Goffredo de Portu

Abstract: In this work, the study of the contact fatigue of an alumina-based laminated composite with compressive residual stress in the surface is...

222
Authors: Štefan Kavecký, Pavol Šajgalík

Abstract: Carbon nanotubes have been prepared by CVD from acetylene-argon gaseous system in tubular flow reactor. Acetylene gas was used as the carbon...

230

Showing 21 to 30 of 63 Paper Titles