High Damping Materials II

Volume 319

doi: 10.4028/www.scientific.net/KEM.319

Paper Title Page

Authors: B. Coluzzi, A. Biscarini, Giovanni Mazzolai, Fabio M. Mazzolai, Ausonio Tuissi, Elena Villa

Abstract: The internal friction (IF) and the Young’s modulus (E) of NiTi based alloys have been investigated at 1 Hz and 1 kHz frequencies after...

Authors: S.H. Chang, Shi Kang Wu

Abstract: Damping capacity and storage modulus of cold-rolled and annealed Ti50Ni50 SMA are systematically investigated by DSC and DMA tests. The...

Authors: Rolf Gotthardt

Abstract: The shape memory effect and the high damping in shape memory alloys are based on the martensitic phase transformation, which takes place...

Authors: Andre Rivière, Veronique Pelosin, G. Covarel, Michel Gerland
Authors: I. Yoshida, Kazuhiro Otsuka

Abstract: Low frequency internal friction of Ti49Ni51 binary and Ti50Ni40Cu10 ternary shape memory alloys has been measured. The effect of solution...

Authors: T. Ueura, Takuya Sakaguchi, N. Igata, Shin Takeuchi

Abstract: Effects of hydrogen doping on the internal friction (IF) of ternary Ti50Ni50-xCux (x=15, 20, 25) shape memory alloys, prepared by rolling...

Authors: Agnieszka Mielczarek, Werner Riehemann, Sönke Vogelgesang, Hennadiy Zak, Babette Tonn

Abstract: The strain amplitude dependent internal friction at room temperature and the transition temperatures of CuAlMn-shape memory alloys with Al...

Authors: Takahiro Sawaguchi, Takehiko Kikuchi, Kazuyuki Ogawa, Fu Xing Yin, Setsuo Kajiwara, Atsumichi Kushibe, Takatoshi Ogawa

Abstract: The damping behavior of an Fe-28Mn-6Si-5Cr-0.5NbC (mass%) shape memory alloy was measured by low cycle fatigue tests during...


Showing 1 to 10 of 36 Paper Titles