Development of Face Magnetic Inductor with Permanent Magnets for Deburring Using MAF Process


Article Preview

Several types of inductors with permanent magnets for deburring using the MAF process were investigated in this paper. The magnetic intensity of each system was measured at working gap to determine the proper system. Using the inductor with a permanent magnet, which was designed and manufactured as a result of the investigation, the heterogeneity of the finishing process and the variations in the location of the magnet poles and the amount of the powder were analyzed during the deburring process. The characteristic curve was calculated from the experimental data and used to compare the performance of each inductor. Under similar conditions, the permanent magnet inductor showed superior performance compared to the electromagnetic inductor in the deburring process.



Edited by:

Dongming Guo, Tsunemoto Kuriyagawa, Jun Wang and Jun’ichi Tamaki




S.L. Ko et al., "Development of Face Magnetic Inductor with Permanent Magnets for Deburring Using MAF Process", Key Engineering Materials, Vol. 329, pp. 237-242, 2007

Online since:

January 2007




[1] Baron, Yu. M. Magnetic Abrasive and Magnetic Processing of Parts and Cutting Tools. Leningrad: Mashinostroenie, 1986, -272p. (Rus).

[2] Skvorchevsky, N. Ya. Study of MAF Productivity and Surface Qualities at Different Coolant ApplicationS. Abstract of a Ph.D. thesis. Minsk: FTI AS BSSR, 1980, -18p. (Rus).

[3] Baron, Y. M.; Ko, S. -L.; and Park, J. I. Technique of Comparison and Optimization of Conditions for Magnetic Abrasive Finishing. Proc. Advances in Abrasive Technology YIII, Key Engineering Materials, Switzerland: TTP, 2005, Vols. 291-292, pp.297-302.


[4] Ko, S. -L.; Chae, J. -W.; Park, J. -I.; Baron, Yu. M.; and Polishuk, V. S. Development of an Effective Magnetic Abrasive Deburring Method using a Vibratory Table. Proc. of the 7 th Int. Conf. on Deburring and Surface Finishing, Berkeley, USA, 2004, pp.355-363.

Fetching data from Crossref.
This may take some time to load.