Study on Processing Parameters of Ceramic Injection Moulding


Article Preview

According to the heat transmission theory, in the aid of computer, the temperature distribution in the cylinder cavity was calculated. The temperature of the mould has much influence on the time for the injection material’s temperature of the cavity center to drop to the injection material softening temperature. The influence of the processing parameters on the density of the injection molding specimens was also investigated. It turns that the injection molding specimens’ density changes little with the increase of injection temperature and pressure, but changes a lot with the increase of holding pressure time.



Key Engineering Materials (Volumes 336-338)

Edited by:

Wei Pan and Jianghong Gong




X. G. Yu et al., "Study on Processing Parameters of Ceramic Injection Moulding", Key Engineering Materials, Vols. 336-338, pp. 1009-1011, 2007

Online since:

April 2007




[1] J. G. Zhang, M. J. Edirisinghe and J. R. G. Evans: Industrial Ceramics Vol. 9 (1989), p.72.

[2] P. S. Allan, M, J. Bevis, M. J. Edirisinghe, J. R. G. Evans, P. R. Hornsby: J. Mater. Sci. Lett. Vol. 6 (1987), p.165.

[3] J. A. Mangels and R. M. Williams: Ceramic Bulletin Vol. 62 (1983), p.601.

[4] T. Zhang: PH. D Thesis, Tsinghua University, (1988).

[5] Z.P. Xie: PH. D Thesis, Tsinghua University, (1993).

[6] X.G. Yu and L. Wang: Bulletin of the Chinese Ceramic Society Vol. 5 (1997), p.55. Fig. 4 The variation of injection moulded cylinder's density with the hold pressure time.