Stable Incremental Deformation of a Strip to High Strain


Article Preview

This paper presents the effect of combined stretching and bending on the achieved strain in incremental sheet forming ISF. A simple two dimensional model of strip undergoing stretching and travelling three point bending in cyclic form is used. The numerical model presents the effect of the ratio of stretching velocity to roll-set speed on the achieved strain and its distribution.



Main Theme:

Edited by:

F. Micari, M. Geiger, J. Duflou, B. Shirvani, R. Clarke, R. Di Lorenzo and L. Fratini




A. Hadoush et al., "Stable Incremental Deformation of a Strip to High Strain", Key Engineering Materials, Vol. 344, pp. 615-620, 2007

Online since:

July 2007




[1] W.C. Emmens, Water jet forming of steel beverage cans, International Journal of Machine Tools & manufacture 46, 2006, pp.1243-1247.


[2] F. Yoshida and M. Urabe, FE simulation of tension levelling process for clad sheet metals, Advanced Technology of Plasticity, vol. 2, Proceeding of the 6th ICTP, 1999, pp.1107-1112.

[3] L.W. Meyer, C. Gahlert and F. Hahn, Influence of an incremental deformation on material behaviour and forming limit of Aluminium Al99, 5 and QT-Steel 42CrMo4, Advanced Materials Research, vol. 6-8, 2005, pp.417-424.


[4] F. Yoshida, T. Uemori and K. Fujiwara, Elastic-plastic behaviour of steel sheets under in-plane cyclic tension-compression at large strain, International Journal of Plasticity, vol. 18, 2002, p.633659.