Theoretic Analysis and Experimental Research on Barrel Finishing Uniformity of Crank Shafts with Larger Size

Abstract:

Article Preview

At present, crankshafts with larger size are finished mostly by abrasive cloth and manual steel brush, which is not ideal on finishing quality, efficiency and cost, especially cleanness degree does not meet design and use request. So horizontal spindle barrel finishing has been developed and has good finishing effects for crankshafts with small size. But this process has bad uniformity for connecting rod journal of crankshafts with larger size by simulation experiments. Aimed at the size, shape and weight of crankshafts with larger size, theoretic research is done, and main factors for finishing uniformity are analyzed. Finally its finishing project is defined and experiments are done. The research indicates that this process is very effective for crankshafts with larger size, and has also positive influence on efficiency and auto product line.

Info:

Periodical:

Key Engineering Materials (Volumes 359-360)

Edited by:

Jiuhua Xu, Xipeng Xu, Guangqi Cai and Renke Kang

Pages:

394-398

Citation:

W. H. Li et al., "Theoretic Analysis and Experimental Research on Barrel Finishing Uniformity of Crank Shafts with Larger Size ", Key Engineering Materials, Vols. 359-360, pp. 394-398, 2008

Online since:

November 2007

Export:

Price:

$38.00

[1] Z.W. Qing: Deburring Technology Handbook (Navigation Press, China 1995). (In Chinese).

[2] S.C. Yang: Surface Quality and Finishing Technology (Machinery Industry Press, China 2001). (In Chinese).

[3] S.Q. Yang, M.Z. Wang, S.C. Yang and M.Z. Wang: China Mechanical Engineering, Vol. 12 (2001) No. 1, pp.300-302. (In Chinese).

[4] S.Q. Yang, W.H. Li and S.C. Yang: Proc. The International Conference on Surface Finishing Ttechnology and Surface Engineering (DaLian, China, September 25-27, 2006), pp.45-48.

[5] W.H. Li, S.C. Yang and S.Q. Yang: Journal of TaiYuan University of Technology, Vol. 33 (2002) No. 1, pp.51-53. (In Chinese).

[6] Z.X. Zhang: MATLAB Program Design and Application (Tsinghua University Press, China 2002). (In Chinese).

[7] S.Q. Yang, M.Z. Wang and Y.W. Wang: China Mechanical Engineering, Vol. 10 (1999) No. 5, pp.502-505. (In Chinese).

[8] W.H. Li, S.Q. Yang and S.C. Yang: Proc. The International Conference on Surface Finishing Ttechnology and Surface Engineering (DaLian, China, September 25-27, 2006), pp.91-94.