Advances in Materials Processing IX

Volume 443

doi: 10.4028/www.scientific.net/KEM.443

Paper Title Page

Authors: You Min Huang, Yi Wei Tsai

Abstract: A methodology of formulating an incremental elasto-plastic three-dimensional finite element model, which is based on Prandtl-Reuss flow rule...

116
Authors: Ryoji Nakamura, Kazuya Akitsu, Takanori Yamabayashi, Shinji Kumai, Hisaki Watari

Abstract: A scraper was equipped to a single roll caster to improve the free solidified surface. The scraper contacted to the free solidified surface...

122
Authors: Ryoji Nakamura, Masakazu Sawai, Ryoji Nakamura, Takanori Yamabayashi, Shinji Kumai, Hisaki Watari

Abstract: A roll caster, which could cast the three layers of clad strip directly from the molten metal, was designed, assembled and tested. The base...

128
Authors: Sutasn Thipprakmas

Abstract: There is an increasing demand for high quality metal stamped parts. In general, burr formation is the main defect found subsequent to the...

134
Authors: Suthep Yiemchaiyaphum, Masahiko Jin, Sutasn Thipprakmas

Abstract: Considering the advantages of the fine-blanking process, the smooth-cut surface without further operation could be fabricated. However, one...

140
Authors: Xiang Long Yu, Quan Yang, Zheng Yi Jiang

Abstract: Using finite element method (FEM), the results of bending conditions of the intermediate plate at the bending rolls of a coilbox between the...

146
Authors: Jürgen Rosenberger, Dietmar Suesse, Sven Hübner, Volker Ulbricht, Bernd Arno Behrens

Abstract: The draw bending process represents an alternative for the flexible and inexpensive production of open sheet metal profiles. This paper...

152
Authors: Cha Yong Lim, Hyoung Wook Kim, Seong Hee Lee

Abstract: The 3-layers accumulative roll bonding process (ARB) has been attempted to increase the strength of copper alloy (Cu-0.02wt.%P) by refining...

158
Authors: Jun Seok Choi, Young Gwan Jin, Yong Taek Im

Abstract: Equal channel angular extrusion (ECAE) was used before and after artificial aging to investigate the effect of heat treatment on formability...

164
Authors: Huan Yong Cui, Xi Jie Tian, Dong Liang Wang

Abstract: Gear tooth profile modification can be featured to improve working stability of gear equipments, abate noise and vibration, enhance loading...

170

Showing 21 to 30 of 126 Paper Titles