Advances in Materials Processing IX

Volume 443

doi: 10.4028/

Paper Title Page

Authors: Hang Jian Guan, Ming Shao, Zhi Yu Xiao

Abstract: High velocity compaction (HVC) is one of the latest technologies of powder metallurgy (PM), while the prices threshold of Hydropulsor’s HVC...

Authors: Young Seon Lee, Taek Woo Jung, Dae Yong Kim, Young Hoon Moon

Abstract: Clad metal sheets are composed of one or more different materials joined by resistance seam welding, roll-bonding process, etc. Good...

Authors: Dae Yong Kim, Bum Kyu Hwang, Young Seon Lee, Sang Woo Kim, Young Hoon Moon

Abstract: The purpose of this work is to experimentally investigate the effect of annealing treatment on the formability and springback at room...

Authors: Aleš Petek, Karl Kuzman, Franc Resman, Boris Jerman, Viktor Zaletelj

Abstract: The technologies for low-quantity production of sheet metal components and parts are applied mostly for thin single metal sheets. However,...

Authors: Sutasn Thipprakmas, Wiriyakorn Phanitwong, Mutjarin Chinwithee, Thanaporn Morkprom

Abstract: Burrs are unwanted materials remaining not only after the machining operation but also after the sheet metal cutting operation. Burr...

Authors: Suthep Butdee, Chaiwat Noomtong, Serge Tichkiewitch

Abstract: Aluminum extrusion die manufacturing is a critical task for productive improvement and increasing potential of competition in aluminum...

Authors: Chih Wei Wu, Chih Heng Chi, Hung Yin Tsai, Yung Kang Shen

Abstract: This paper presents an innovative fabrication of a large-area silicon mold with microstructures. Conventional techniques capable of...

Authors: Suthep Yiemchaiyaphum, Masahiko Jin, Sutasn Thipprakmas

Abstract: The hole quality on sheet metal parts is directly dependent on the die design and process parameters. In conventional piercing process, the...

Authors: Md Shahanur Hasan, Md Mazid Abdul, Richard E. Clegg

Abstract: Stellites are cobalt based super alloys. By virtue of their excellent physio-mechanical properties, stellites are highly regarded...

Authors: Jong Leng Liow, Ulrich Frye

Abstract: The surfaces of Al6061, machined by 150 μm two flute micro end-mills, were studied to determine their roughness. The surface roughness, Ra,...


Showing 31 to 40 of 126 Paper Titles