Paper Title:
Microstructure and Thermal Stability in CP Titanium Processed by Electroplastic Rolling
  Abstract

Ultrafine-grained (UFG) CP titanium (Grade-4) sample was processed by electroplastic rolling (EPR) at room temperature which was compared to a specimen processed by conventional cold rolling (CR). EPR was performed using pulsed unidirectional current with a current density of 95 A/mm2, pulse duration of 10-4 s and frequency of 1000 Hz. It was found that the sample processed by EPR has slightly higher dislocation density and smaller crystallite size than for the CR specimen resulting in a higher tensile strength for the former specimen. In the case of EPR sample, the relative fraction of dislocations is lower than for CR specimen. During annealing the relative fraction of dislocations decreased for both samples which can be explained by the fact that the dislocations have larger Burgers-vector and consequently higher formation energy than the other two types.

  Info
Periodical
Edited by
Pavel Šandera
Pages
215-218
DOI
10.4028/www.scientific.net/KEM.465.215
Citation
J. Gubicza, E. Khosravi, V. V. Stolyarov, "Microstructure and Thermal Stability in CP Titanium Processed by Electroplastic Rolling", Key Engineering Materials, Vol. 465, pp. 215-218, 2011
Online since
January 2011
Export
Price
$35.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Jenő Gubicza, Magdy Kassem, Tamás Ungár
Abstract:The effect of the nominal Mg content and the milling time on the microstructure of mechanically alloyed Al(Mg) solid solutions is...
103
Authors: Bjoern Reetz, Walter Reimers
Abstract:The brass alloys CuZn10 and CuZn37 were cold deformed by uniaxial compression in steps of 5 % res. 10 % to 20 %. Using X-ray synchrotron...
937
Authors: J.L. Collet, Françoise Bley, Alexis Deschamps, Colin Scott
Abstract:The deformation mechanisms of an Fe-Mn-C TWIP steel have been investigated as a function of deformation and deformation temperature, using...
822
Authors: Stephan Scheriau, K. Rumpf, Siegfried Kleber, Reinhard Pippan
Abstract:Industrial available FeSi, FeCo and FeNi alloys with an initial grain size of 20-50 m were subjected to Severe Plastic Deformation (SPD) up...
923
Authors: Ilya Nikulin, Rustam Kaibyshev
Tuesday
Abstract:Grain refinement taking place in a commercial 7055 aluminum alloy under equal channel angular pressing (ECAP) was examined in the temperature...
317