Materials Structure & Micromechanics of Fracture VI

Volume 465

doi: 10.4028/www.scientific.net/KEM.465

Paper Title Page

Authors: Anja Weidner, Horst Biermann

Abstract: The tensile and cyclic deformation behaviour of a new metastable austenitic stainless cast steel were studied in-situ in a scanning electron...

350
Authors: Radomila Konečná, S. Fintová, Gianni Nicoletto

Abstract: The fatigue strength of cast Al-Si alloys is strongly sensitive to the presence of casting defects. Extensive rotating bending fatigue...

354
Authors: M.F. Giordana, I. Alvarez-Armas, Maxime Sauzay, A.F. Armas

Abstract: The cyclic behaviour of the steel EUROFER 97 during isothermal plastic strain-controlled tests was investigated at room temperature and at...

358
Authors: Per Hansson, Solveig Melin

Abstract: The influence on the fatigue crack growth behaviour of a short edge crack due to different configurations of a nearby located low angle...

362
Authors: Paola Antonaci, Pietro G. Bocca, Davide Masera

Abstract: Experimental researches conducted in recent years at the Non Destructive Testing Laboratory of Politecnico di Torino have revealed an...

366
Authors: Paola Antonaci, Pietro G. Bocca, Davide Masera

Abstract: The aim of this work is to analyse the mechanical response of the masonry specimens under long-term action by means of cyclic tests. To this...

370
Authors: Victor V. Kozhushko, Günther Paltauf, Heinz Krenn, Reinhard Pippan

Abstract: Disc-shaped specimens of nickel and iron of about 30 mm diameter and a few millimeters thick were prepared by the high pressure torsion...

374
Authors: Zuzanka Trojanová, Zoltán Száraz

Abstract: Mg8Li alloy reinforced by 7 vol.% SiC particles was processed by a powder metallurgical method. Samples were deformed in tension and...

378
Authors: Marie Kvapilová, Vaclav Sklenička, Jiří Dvořák, Petr Král

Abstract: Our earlier published creep data are analyzed for ultrafine-grained pure aluminium and copper processed by equal-channel angular pressing...

382
Authors: Petr Kawulok, Rostislav Kawulok, Ivo Schindler, Jaroslav Sojka, Martin Kraus, Karel Milan Čmiel, Miroslav Legerski, Stanislav Rusz

Abstract: A physical simulation of the thermomechanical processing of the Mn-Ni-Cr-Mo low-alloy steel was performed in the laboratory rolling mill...

386

Showing 81 to 90 of 137 Paper Titles