Theory and Practice of Technology for Machining Non-Rigid Smooth Shafts


Article Preview

In modern machine-building the problem of creating highly-efficient technological mechanical machining processes, taking into account the energy and resources-saving and ecological requirements is one of the paramount importance. Throughout the whole period of machine-building technology development there were great difficulties owing to the problems of machining parts with low rigidity and high demands on quality. At creating the technological processes of similar parts’ machining, as at creating any technological process, it is necessary to provide realization of the principle of combining technical, economic and organization assignments. But unlike usual technological processes, in this case it is much more difficult to meet all these requirements.



Edited by:

Michael N. Morgan, Andrew Shaw and Otar Mgaloblishvili




Y. Maximov, "Theory and Practice of Technology for Machining Non-Rigid Smooth Shafts", Key Engineering Materials, Vol. 496, pp. 168-175, 2012

Online since:

December 2011





[1] Yu.V. Maksimov: Combined Cutting and Plastic Deformation, Avtomobilnaya Promyshlennost /Automotive Industry/, N6, 1990, pp.21-23.

[2] A. V. Ankin, G. S. Karasev. Influence of torsional vibration on the accuracy machining of non-rigid shafts. Tractors and agricultural machines No. 5, 2007, pp.55-56.

[3] Yu.V. Maksimov, G.M. Azrevich, R.V. Loginov: High-Precision Finishing of Smooth Large Dimensional Shafts, Himicheskoye i Neftegazovoe Machinostroenie /Chemical and Oil-Gas Machine-Building/, N7, 1999, pp.41-44.

[4] A. V. Ankin, E. A. Vetrova: Influence of fluctuations of the cross section of non-rigid of a hollow cylinder type on the cutting force during combined machining and surface plastic deformation. Izvestiya MGTU MAMI, No. 1 (9), 2010, pp.158-162.

[5] Yu.V. Maksimov: The Patent of RF N2134631, The Method of Combined Treatment and the Device for its Realization, published in Bulleten Izobreteniy /The Inventions' Bulletin/, N23, (1999).