Effect of Thermomechanical Parameters on Texture of 90-10 Brass Sheets

Abstract:

Article Preview

Optimized conditions of hot and cold rolling followed by annealing can result in a balance between recrystallization and rolling textures in order to reduce the planar anisotropy of brass sheets. In this work, the effect of finish rolling temperature, cold reduction and annealing temperature on texture development has been investigated. It is shown that uniform deformation at higher finishing temperature is responsible of formation of a severe Cube and G texture components. In contrast, mechanical twinnings are widely formed at low finishing temperatures. There is also a direct relation between the intensity of Cube component and the amount of cold reduction.

Info:

Periodical:

Materials Science Forum (Volumes 495-497)

Edited by:

Paul Van Houtte and Leo Kestens

Pages:

755-760

DOI:

10.4028/www.scientific.net/MSF.495-497.755

Citation:

M. Salari et al., "Effect of Thermomechanical Parameters on Texture of 90-10 Brass Sheets", Materials Science Forum, Vols. 495-497, pp. 755-760, 2005

Online since:

September 2005

Export:

Price:

$35.00

[1] W.B. Hutchinson and H.E. Ekstrom, Materials Science and Technology, Vol 6, P. 1103-1111, (1990).

[2] F.J. Humphery and H. Hatherly, Recrystallization and Related Annealing Phenomena, Elsevier Science, (1996).

[3] J. Hirsch, K. Lucke and M. Hatherly, Acta Metallurgy, Vol. 36, No. 11 , pp.2905-2927, (1988).

[4] J. Hirsch and K. Lucke , Acta Metallurgica, Vol . 36, No. 11, pp.2863-2882, (1988).

[5] M. Hatherly, A. Malin, C. Carmichael, F. Humphreys and J. Hirsch, Acta Metallurgica, Vol. 34, pp.247-2257, (1986).

[6] S. Hong and D. Lee, Materials Science and Engineering, A351, p . 133-147, (2003).

[7] A.A. Ridha and B. Hutchinson, Acta Metallurgica, Vol. 30, pp.1929-1939, (1982).

[8] H. Yiu, J. Savoie and E. Lauridsen, Materials Science Forum, vols 408-412, pp.1501-1506, (2002).

In order to see related information, you need to Login.