Brazing of Al2O3 with Rapidly Solidified Melt Spun Ni-Cr-P Alloy Ribbons

Abstract:

Article Preview

Melt spun Ni-Cr-P alloy ribbons were used as filler metal to join Al2O3 substrates together using a vacuum brazing process. The influence of the brazing load, brazing temperature and holding time on the shear resistance of brazed joints was evaluated. The experimental results showed that the holding time was the most important parameter. At a brazing temperature of 1060°C, the shear resistance value increased from 6.17 to 93.7 MPa with increasing brazing time from 20 to 100 min, respectively.

Info:

Periodical:

Materials Science Forum (Volumes 530-531)

Edited by:

Lucio Salgado and Francisco Ambrozio Filho

Pages:

473-477

Citation:

T.M. Maciel et al., "Brazing of Al2O3 with Rapidly Solidified Melt Spun Ni-Cr-P Alloy Ribbons", Materials Science Forum, Vols. 530-531, pp. 473-477, 2006

Online since:

November 2006

Export:

Price:

$38.00

[1] S. Mandal. and A.K. Ray, Materials Science & Engineering (2004), p.2.

[2] H. Hongqi,., J. Zhihao., Xiaotian, Journal of Materials Science 32 (1997), p.5011.

[3] D. Janickovic., et al., Materials Science and Engineering A304-306 (2001), p.569.

[4] P. Duhaj., et al., Materials Science and Engineering A271 (1999), p.181.

[5] Y. N Liang., M.I. Osendi., P. Miranzo., Journal of the European Ceramic Society 22 (2002), p.1.

[6] M.R. Rijnders. and S.D. Peteves., Scripta Materialia, 41 (1999), p.1137.

[7] D. Szewieczek. and J. Tyrlik., Journal of Materials Processing Technology 53 (1995).

Fetching data from Crossref.
This may take some time to load.