High Speed Deformation of Ultrafine Grained TWIP Steel

Abstract:

Article Preview

Tensile properties of twinning induced plasticity (TWIP) steels (31%Mn-3%Al-3%Si-Fe) with various mean grain sizes ranging from ultrafine grain size (1.1μm) to conventional one (35.5μm) at a wide range of strain rates from 10-3sec-1 to 103sec-1 were studied. The ultrafine grained TWIP steel exhibits a large work hardening and keeps an adequate elongation at any strain rate. The strength held to the Hall-Petch relationship at each strain rate and the Hall-Petch slopes do not change largely.

Info:

Periodical:

Materials Science Forum (Volumes 561-565)

Main Theme:

Edited by:

Young Won Chang, Nack J. Kim and Chong Soo Lee

Pages:

107-110

Citation:

R. Ueji et al., "High Speed Deformation of Ultrafine Grained TWIP Steel", Materials Science Forum, Vols. 561-565, pp. 107-110, 2007

Online since:

October 2007

Export:

Price:

$38.00

[1] W. -S. Lee and C. -F. Lin, Mater. Sci. Eng. A Vol. 308 (2004) p.124.

[2] O. Grässel, L. Krüger, G. Frommeyer and L. W. Meyer, Int. J. Plasticity Vol. 16 (2000) p.1391.

[3] N. Tsuji, Y. Saito, S. H. Lee and Y. Minamino, Adv. Eng. Mater. Vol. 5 (2003) p.338.

[4] Y. Chuman, K. Mimura, K. Kaizu and S. Tanimura, Int. J. Impact. Eng. Vol. 19 (1997) p.164.

[5] N. Tsuji, Y. Ito, Y. Saito and Y. Minamino, Scripta Mater. Vol. 47 (2002) p.893.

[6] J. D. Campbell JD and W. G. Ferguson, Phil. Mag. Vol. 21 (1970) p.63.

[7] N. Tsuchida, Y. Tomota and K. Nagai, Tetsu-to-Hagane Vol. 90 (2004) p.1043 Fig. 4 Hall-Petch relationships of the TWIP steels tensile tested at 10-3sec-1 to 102sec-1. The values of slopes (k) were also denoted.

Fetching data from Crossref.
This may take some time to load.