Study on Dynamic Measurement of Thermal Stress during Solidification of a Casting Specimen


Article Preview

A method was presented for the indirect measurement of dynamic stress of casting in this paper. A stress sensor embedded in the sand mold close to the casting was used to reveal the pressure resulted by the shrinkage of casting which could figure out the dynamic stress of the frame-shaped casting indirectly. The numerical simulation was also carried out by FDM/FEM method. The results showed that the pressure grew up quickly in the rapid cooling period and then kept on a steady value. The experimental and calculated results were in good agreement.



Materials Science Forum (Volumes 561-565)

Main Theme:

Edited by:

Young Won Chang, Nack J. Kim and Chong Soo Lee




J. F. Zhang et al., "Study on Dynamic Measurement of Thermal Stress during Solidification of a Casting Specimen", Materials Science Forum, Vols. 561-565, pp. 1841-1844, 2007

Online since:

October 2007




[1] B. C. Liu, T. Jing. China Machine Press (2001), p.113.

[2] J. P. Zhu, H. M. Shao. China Machine Press (1983), p.19.

[3] H. Guo, D. W. Zuo, S. H. Wang, et al. Journal of South China University of Technology (Natural Science Edition). Vol. 34 (2006), p.33.

[4] E. Carrera, A. Rodríguez, J. Talamantes, et al. Journal of Materials Processing Technology. Vol. 189 (2007), p.206.

[5] Z. H. Yin, H. Huang, L. Gu. Mechanical Engineer. Vol. 2 (2005), p.80.

[6] John W. Wilson, Gui Yun Tian, Simon Barrans. Sensors and Actuators A: Physical. Vol. 135 (2007), p.381.

DOI: 10.1016/j.sna.2006.08.010

[7] Y. H. Bi, L. Z. Shen, Y. Z. Yang, et al. Transactions of the Chinese Society for Agricultural Machinery. Vol. 37 (2006), p.163.

[8] J. W. Kang. PHD Theses of Tsinghua University (1998), p.68.

Fetching data from Crossref.
This may take some time to load.