The Research of Thermal Arc Sprayed Coatings Tribological Properties by Using Rubber Wheel Test

Abstract:

Article Preview

This paper present the result obtained from new experimental STEIN-MESYFIL 953 V; STEIN-MESYFIL 954 V coatings. The surfacing material was wires of 1.6 mm diameter. The tests aimed at determining wear resistance of coatings sprayed on steel substrate. The investigation shows that the tribological behaviour of new experimental thermal arc sprayed coatings is greatly affected by its microstructural constituents such as porosity, oxide inclusions, and microhardness of coatings. Results show that increasing porosity of coatings twice, it doubles the mass loss. Results for thermal sprayed coatings of all experiments showed their high wear resistance and are discussed.

Info:

Periodical:

Solid State Phenomena (Volumes 220-221)

Edited by:

Algirdas V. Valiulis, Olegas Černašėjus and Vadim Mokšin

Pages:

693-697

Citation:

J. Gargasas et al., "The Research of Thermal Arc Sprayed Coatings Tribological Properties by Using Rubber Wheel Test", Solid State Phenomena, Vols. 220-221, pp. 693-697, 2015

Online since:

January 2015

Export:

Price:

$38.00

* - Corresponding Author

[1] Handbook of Thermal Spray Technology, ASM Thermal spray society, 2004, p.5–232.

[2] F. -W. Bach, A. Laarmann, T. Wenz, Modern Surface Technology, 2006, p.128–136.

[3] A. Wank, B. Wielage, H. Pokhmurska, E. Friesen, G. Reisel, Comparison of Hardmetal and Hard Chromium Coatings Under Different Tribological Conditions, 2006, p.1975–(1980).

DOI: https://doi.org/10.1016/j.surfcoat.2006.04.058

[4] Thermal Spraying Plasma, Arc and Flame Spray Technology, 2008, p.83–166.

[5] B.S. Schorr, et al., Mater. Charact. 42 (1999) 93–100.

[6] N. Branland, E. Meillot, P. Fauchais, A. Vardelle, F. Gitzhofer, M. Boulos, Journal of Thermal Spray Technology 15(1) (2006) 53–62. Information on http: /link. springer. com/journal/11666/15/1/page/1.

DOI: https://doi.org/10.1361/105996306x92596

[7] Standard Test Method for Measuring Abrasion Using the Dry Sand/Rubber Wheel Apparatus G 65–94, reapproved (2000).

DOI: https://doi.org/10.1520/g0065-04r10