Papers by Author: Laurent Dubourg

Paper TitlePage

Authors: Simon Larose, Laurent Dubourg, C. Perron, Mohammad Jahazi, Priti Wanjara
Abstract: Friction stir welding (FSWing) induces residual stresses and distortions in welded structures. Such residual stresses reduce the fatigue life of welded components, while the induced distortions prevent the welding of large or thin components. In the present study, needle peening was used to induce additional residual stresses in 2.3-mm thick (FSWed) aluminum alloy (AA) 2024-T3 sheets. This was done with the objective to counterbalance the welding-induced stresses and thus reduce the overall stresses and distortions. The needle peening process, which stems from shot peening, consists of hammering a surface using cylindrical spherical ended shots sliding back and forth in a treatment head. An instrumented needle peening machine was used to carry out peening on as-received (or bare) and bead-on-plate FSWed AA2024-T3 material. In both cases, the width of the peening area corresponded to that of a typical weld. The influence of the peening process parameters such as needle size, applied power and travel speed on the surface quality and magnitude of the induced distortions were evaluated. The results indicate that, by increasing the needle diameter from 1.2 mm to 2.0 mm, the peening-induced deflection on bare sheet material increased by an average value of 27% while the roughness average, Ra, decreased by an average value of 47%. It was also found that a surface finish qualitatively similar to that of conventional shot peening could be obtained by using appropriate needle peening trajectories. Finally, needle peening with an applied power of 10% was sufficient for eliminating 37% of the welding-induced transverse curvature and 82% of the welding-induced longitudinal curvature.
Authors: Laurent Dubourg, P. Doran, Michael A. Gharghouri, Simon Larose, Mohammad Jahazi
Abstract: Friction Stir Welding (FSW) induces thermal residual stresses resulting in distortions in thin-walled structures. In order to understand and quantify this phenomenon, simulations and experiments of FSW on aluminium alloy (AA) 2024-T3 have been performed using different rotational and welding speeds. A sequentially coupled finite element (FE) model was used to study the residual stresses caused by the thermal cycling induced from FSW. The 3D FE model used temperature-dependent mechanical and thermophysical material properties. The predicted longitudinal stresses peaked at ~300 MPa and had a ‘‘W’’ profile with tensile stress peaks in the weld and compressive stresses outside the weld. In the FE model, the influence of process parameters on residual stress distribution was studied. The application of ‘hot’ welding conditions, i.e. low welding speed and high rotational speed, increased the residual stresses significantly, mainly in the transverse direction. Conversely, ‘cold’ welding conditions resulted in lower residual stresses. The magnitude and distribution of the residual stresses predicted by the FE model were validated by neutron diffraction. The results indicate a good agreement between the measured and predicted residual stresses in AA2024-T3.
Showing 1 to 2 of 2 Paper Titles