Papers by Author: Shao Ming Zhang

Paper TitlePage

Authors: Bi Cheng Yang, Shao Ming Zhang, Jun Xu, Li Kai Shi, Z. Fan
Abstract: The billet of magnesium AZ31B was made by twin-screw rheo-cast, and the specimen cut from the rheo-cast billet and normal cast billet were compressed in Gleeble-3000 hot simulator. The deformation temperature was 300, 350, and the strain rates were 0.001~1s-1. The relationship among flow stress, deformation temperature and strain rates were analyzed. The variation of the microstructure was observed and compared after the specimen was hot compressed. The results show that the surface of the rheo-cast specimen is much more smooth than the normal cast specimen after the compression. The dynamic recrystallization had taken place during the compression and the recrystallized grain of rheo-cast sample is more tiny than normal cast specimen.
Authors: Jun Xu, Shao Ming Zhang, Bi Cheng Yang, Li Kai Shi, Z. Fan
Abstract: A new rheo-extrusion technique has been developed to produce extruded profiles. The AZ31 slurry is fabricated by a twin-screw mechanism, and has spheroidal solid particles with a grain size of about 50 to 80μm. The slurry was introduced into an extrusion container with an inner diameter of 95mm, and then squeezed to a billet before extruding into a round bar with a diameter of 22mm using a 500kN extrusion machine. It is found that the new technique has a lower deformation resistance than that of the conventionally hot extrusion technique in the same extrusion velocity. The microstructure and mechanical properties of the rheo-extruded bars were examined in detail. The results illustrated that grains of the bar were very fine with the average grain size about 2.3μm,and the mechanical properties were improved substantially compared with those of the same alloy produced by the conventional hot extrusion.
Authors: Ji Juan Zhang, Shao Ming Zhang
Abstract: Countertop of integrated cabinet is the maximum number of contacts and the highest cost component, its material quality directly determines the final using functions. Artificial stone is an ideal material for the cabinet countertop, in order to solve its high cost, easy to crack and deformation problem, we try to develop a new technology to manufacture wood-based artificial stone composite board, which take particle board as core material and artificial stone as a surface material. Article studied the mechanism of composite materials, analyzed the selection principle of raw material for wood-based artificial stone composite countertop, designed two form structure of wood-based artificial stone composite countertop for integrated cabinet. Studied the process techniques and determined the production technology lines and optimum process parameters. Wood-based artificial stone composite countertop not only saved the usage amount of artificial stone, but also retain its lots of advantages, and improved strength, reduced costs, opening up the application scope of artificial stone materials.
Authors: Xin Ming Zhao, Jun Xu, Xue Xin Zhu, Shao Ming Zhang
Abstract: The aspiration pressure variation at the tip of metal delivery tube in the supersonic atomization nozzle during gas-only atomization performance had been investigated in this work. The results reveal that the aspiration pressure is subambient at all operating pressures. A general trend is that with increasing atomization gas pressure, the value of aspiration pressure decreases at P0 between 0.5 and 1.5MPa, then increases as P0 ranges from 1.5~3.5MPa, finally decreases again at higher gas pressure (P0>~3.5MPa). When P0>2.0MPa, as the included angle α augments, the aspiration pressure ΔP increases. Meanwhile, the change range of aspiration pressure ΔP significantly enlarges when the jet included angle α raises from16 to 28º. The lager is the apex angle β of metal delivery tube, the greater is the aspiration pressure ΔP. And as the protrusion length of melt delivery tube h increases, the aspiration pressure ΔP decreases gradually.
Showing 1 to 4 of 4 Paper Titles