Papers by Author: Frantisek Cerny

Paper TitlePage

Authors: Frantisek Cerny, Mohamed Ali Khalil Ibrahim, Jan Suchanek, Svatava Konvickova, Vladimir Jech, Zdenek Horak
Abstract: The effect of gamma irradiation and subsequent thermal treatment on the wear resistance and friction behavior of ultrahigh molecular weight polyethylene (UHMWPE) has been studied. Irradiation of the polymer was performed using a 60Co γ-emitter at laboratory temperature. Radiation dose 50 kGy was applied. Some irradiated samples were thermally treated at 150˚C for period of 30 min. and then slowly cooled to room temperature. A linear reciprocating tribometer was used to investigate the wear behavior of UHMWPE against Co-Cr-Mo alloy. The tests have been performed in unlubrication conditions. An important increase in wear resistance of the modified UHMWPE in comparison with the original material was proved. Besides wear rate the selected mechanical characteristics (friction coefficient, Young’s modulus, yield strength, fracture strength, and hardness) of original and modified samples of UHMWPE have been determined.
207
Authors: Frantisek Cerny, Jan Gurovic, Vladimir Jech, Svatava Konvickova
Abstract: Multifunctional wear and corrosion resistant decorative nanostructured carbon-base coatings were prepared by PACVD (Plasma Assisted Chemical Vapour Deposition) method on steel substrates. As the multifunctional coating the carbon-base, particularly DLC (Diamond-Like Carbon) nanolayer, was chosen. For the deposition of adherent DLC coating on steel substrate a very thin Si-O-C interlayer was applied in some cases. Deposition of DLC coating and Si-O-C interlayer was performed using dc plasma without additional heating and with the HMDSO (hexamethyldisiloxane) and methane as precursors. During coating growth with increasing of thickness of DLC nanolayer the colour of nanolayer is changed. Whole spectrum of attractive colours is obtained, what is possible to use to decorative purposes. Effect of film thickness on colour is following: The reference specimen (bare stainless steel) has a bright metallic sheen. In the order of increasing thickness, the DLC films produced by PACVD have colours as follows: dark violet at ~75 nm; medium blue at ~130 nm; golden light at ~170 nm; deep rose pink at ~240 nm; golden brown at ~320 nm; and soot black at ~1200 nm. Decorative coatings must be adherent and hard for good wear resistance. Adhesion was tested by scratchtester and microhardness was determined by nanoindentation. The microhardness data were thickness-dependent, influenced by substrate. The highest measured value was 23 GPa. Tribology of the coatings was assessed by wet friction tests.
237
Showing 1 to 2 of 2 Paper Titles