Papers by Author: I. Sinclair

Paper TitlePage

Authors: S. Christensen, J.S. Kandola, O.P. Femminella, S.R. Gunn, P.A.S. Reed, I. Sinclair
533
Authors: Marco J. Starink, I. Sinclair, Nong Gao, Nicolas Kamp, Peter J. Gregson, P.D. Pitcher, A. Levers, Simon Gardiner
601
Authors: Yuan Xu, Peter J. Gregson, I. Sinclair
1525
Authors: T.F. Morgeneyer, Marco J. Starink, I. Sinclair
Abstract: Analysis of toughness in 6156 Al-Mg-Si-Cu sheet has been performed using enhanced Kahn tear tests on samples quenched at different rates, whilst microstructures of the samples have been assessed using differential scanning calorimetry, scanning electron microscopy and transmission electron microscopy. Crack initiation energies were unaffected by changing water quench temperature from 20°C to 60°C, however a significant reduction was evident on air cooling. Crack propagation resistance was reduced for both 60°C water quenched and air cooled materials. The failure morphology of the air cooled material appears consistent with classical intergranular ductile failure. Coarse voiding and shear decohesion was prevalent in the 20°C water quenched material, whilst the 60°C water quenched material showed a mixture of transgranular and intergranular fracture modes. Changes in microstructure and precipitation behaviour resulting from reduced quenching rate were identified and related to the observed fracture behaviour, particularly in terms of precipitate free zone formation and the simultaneous presence of coarse particles at grain boundaries.
1023
Authors: L.J. Venning, I. Sinclair, P.A.S. Reed
Abstract: The effects of alloy production method on microstructure and hence fatigue crack growth rate and fracture mechanism have been examined for a variety of fine-grained/high dispersoid Al-Li-Mg-Zr and Al-Li-Cu-Mg-Zr alloys. Microstructures have been assessed by scanning and transmission electron microcopy, together with electron back scattered diffraction pattern assessment. In these fine-grained/high dispersoid materials, high crack growth rates are seen in comparison to the traditional DC cast alloys, excepting a material with high volume fraction of shearable precipitate. The effects of fracture surface roughness and closure levels in determining crack growth rates has been assessed.
1077
Authors: D. Booth, I. Sinclair
1671
Authors: F. Lefebvre, Shao Ping Wang, Marco J. Starink, I. Sinclair
1555
Authors: Nicolas Kamp, I. Sinclair, Marco J. Starink
1335
Authors: J. Boselli, P.D. Pitcher, Peter J. Gregson, I. Sinclair
1433
Showing 1 to 10 of 12 Paper Titles