Papers by Author: Maria Jovita Oliveira

Paper TitlePage

Authors: E.C. Ferreira, M.F. Costa, C.R. Laranjeira, Maria Jovita Oliveira, António Sergio Pouzada
467
Authors: Júlio C. Viana, João F. Mano, Zlatan Z. Denchev, Maria Jovita Oliveira, Maria Clara Cramez
Abstract: In this work, the structural evolution and damage of PET during stretching is assessed by wide- and small-angle X-ray scattering (respectively, WAXS and SAXS) experiments in specimens pre-deformed at different strain levels (ex-situ characterization). Injection moulded PET rectangular tensile specimens were stretched (at 2 mm/min) into the plastic domain in a universal test machine at different strain levels at room temperature. The structure of the central zone of the deformed specimens was then characterized by WAXS and SAXS experiments using an X-ray synchrotron source. PET was initially (before stretching) amorphous. A strong molecular orientation in the stretching direction is quickly developed for the initial plastic deformation levels, evidenced by strong equatorial WAXS reflections. This orientation rapidly levels off, remaining constant during further stretching. The WAXS patterns are accompanied with no reflections on SAXS, evidencing a local ordering phenomenon, typical of nematic liquid-crystalline structures. The SAXS patterns evidence the occurrence of some voiding in the cold drawing regime just after yielding. These anisotropic voids are oriented perpendicular to the stretching direction, as in a craze-like structure. The void size drastically increases at the onset of the strong strain hardening behaviour.
1583
Authors: Nadya Dencheva, Maria Jovita Oliveira, Olga S. Carneiro, Teresa G. Nunes, Zlatan Z. Denchev
Abstract: The objective of this study is to manufacture and investigate novel nanostructured polymer composites (NPC) based on oriented blends of high-density polyethylene (HDPE) and polyamide 6 (PA6). Conventional polymer processing techniques are used for this purpose including extrusion blending, cold drawing and compression molding. Thus, various polymer blends are prepared comprising 10 and 20 wt% of PA6 and 0-10 wt% of a copolymeric compatibilizer. These blends are cold-drawn to high draw ratios and the oriented strands so produced are further compression molded at various temperatures between the melting points of HDPE and PA6. All NPC obtained are characterized by microscopy techniques, solid state NMR, mechanical tests and wide- and small-angle X-ray scattering from synchrotron. The mechanical and structural data of NPCs are discussed with relation with the polyamide fibrils’ orientation, as well as with the effect of compatibilizer at the matrix-fibrils interface.
515
Authors: A.J. Pontes, Maria Jovita Oliveira, António Sergio Pouzada
814
Showing 1 to 4 of 4 Paper Titles