Papers by Author: Roman Šturm

Paper TitlePage

Authors: Roman Šturm, Janez Grum
Abstract: The present paper deals with residual stress and strain changes in thin flat specimens of nodular cast iron during laser remelting process. In laser remelting process of a workpiece we have used several laser beam passages across the workpiece surface. The state of internal stress in the workpiece changes because of different ways of guiding the laser beam across the workpiece surface, and consequently strain of the workpiece may occur. In the process of gradual remelting of the specimen surface, i.e. during its heating and cooling, volume changes in the specimen surface layer occur due to thermal and microstructural changes. To find out more about volume changes in the thin surface layer of specimens, the latter were monitored by measuring the strain at the lower side of the specimens during and after the remelting process, and also by residual stress measurement in the thin surface layer. The results obtained confirm that the laser remelting process could be successfully optimised on the basis of knowing the residual stresses and the strain generated during the remelting process.
188
Authors: Janez Grum, Roman Šturm
Abstract: Laser remelting process is a very promising hardening method for ferrous and nonferrous alloys, which do not show a homogeneous microstructural state after having been heattreated in a traditional way. Consequently, the alloys concerned do not achieve the required hardness of the surface layer and do not provide the required wear resistance either. The paper deals with residual stresses of thin flat specimens of nodular cast iron 500-7 in the laser remelting process. In the process of gradual remelting of the specimen surface, that is during its heating and cooling, volume changes of the specimen occur due to thermal and microstructural changes. For a better knowledge of volume changes in the thin surface layer of the specimen, the latter were evaluated by residual-stress measurement in the thin modified surface layer after the remelting process. In laser remelting of a workpiece such remelting conditions should be ensured that a uniform thickness of the modified layer could be obtained in spite of several laser-beam passages across the workpiece surface. Because of a multiple laser-beam passage across the workpiece surface, the state of internal stress in the workpiece changes. Optimal laser surface remelting conditions on the basis of knowing the residual stresses were chosen, while the way of guiding the laser beam over the surface of flat samples and degree of overlapping were varied.
460
Showing 1 to 5 of 5 Paper Titles