Papers by Author: Srinivasan Chandrasekar

Paper TitlePage

Authors: Dinakar Sagapuram, Mert Efe, Wilfredo Moscoso, Srinivasan Chandrasekar, Kevin P. Trumble
Abstract: Deformation microstructure and texture in Mg-AZ31B bulk strips processed through extrusion-machining were studied as a function of deformation temperature. At warm deformation temperatures (~200°C), cold-worked type microstructures with predominant tilted basal texture were observed. With increase in temperature, grain structure sharply transformed into equiaxed type with predominant in-plane basal texture. This sharp transition was found to be consistent with change in temperature dependent dynamic recrystallization mechanism from continuous to discontinuous type.
52
Authors: Srinivasan Swaminathan, Terry R. McNelley, Srinivasan Chandrasekar
Abstract: FCC materials were subjected to large strain deformation by three techniques: equal channel angular pressing (ECAP), plane-strain machining and friction stir processing (FSP). Based on the orientation imaging mapping (OIM) analysis of the deformed regions, the most likely microstructure refinement mechanisms have been identified for each of the techniques and compared among one another.
143
Authors: Tejas G. Murthy, C. Huang, M. Ravi Shankar, Srinivasan Chandrasekar, Kevin P. Trumble, John P. Sullivan
Abstract: The temperature and strain rate fields in severe plastic deformation (SPD) are measured using infra-red thermography and Particle Image Velocimetry (PIV), respectively. Plane strain machining is used as the method of SPD to impose controlled strains and strain rates. For metals such as titanium, the temperature rise is small at small strain rates and SPD occurs at near-ambient temperature. The possibility of exploring dynamic recovery/recrystallization phenomena using the Zener-Hollomon parameter in this SPD framework is briefly discussed.
231
Showing 1 to 3 of 3 Paper Titles