Papers by Author: Wen Jie Zhang

Paper TitlePage

Authors: Hua Zhi Gu, Hou Zhi Wang, Yan Ruo Hong, Jia Lin Sun, Wen Jie Zhang
Abstract: Hydration resistance of three commercially available high-purity MgO-CaO clinkers were investigated and compared in the present paper. The results show that, as well as CaO content, microstructural morphology of MgO–CaO clinker affects its hydration resistance. The microstructure in which CaO is present at the grain boundaries of MgO leads to poorer hydration resistance, whereas the one in which CaO and MgO are distributed alternately confers much improved hydration resistance on the clinker, especially when MgO level is high enough to cover most of the CaO crystals.
1679
Authors: Hua Zhi Gu, Rong Dan Shao, Wen Jie Zhang, Hou Zhi Wang, Kai Bao Yang, Shu Zhong Yu
Abstract: SiC whisker was produced through the reaction between carbon and silicon powders during the sintering of Al2O3-ZrO2-C materials. The thermodynamic conditions and growth mechanism were discussed. The results showed that rod-shaped and dumbbell-shaped SiC whiskers are formed, respectively. The main composition of the beads in dumbbell-shaped whisker is SiOX with a small amount of Na and Ca, but the rods are SiC. In addition, the dumbbell-shaped SiC whisker contributed less than straight rod-shaped SiC whisker to improving the physical properties of Al2O3-ZrO2-C materials.
1263
Authors: Hua Zhi Gu, Hou Zhi Wang, Jia Lin Sun, Wen Jie Zhang, Dong Zhi Hou, Cheng Ji Deng, Yan Ruo Hong
379
Authors: Bin Xiang Fang, Bo Quan Zhu, Wen Jie Zhang, Xue Dong Li, Zheng Yun Fan
Abstract: The Al/AlN bonded corundum based multiphase material was prepared by raw materials of fused alumina and metallic aluminum powder by in situ reaction at 1100°C for 3h in N2 . The XRD analysis showed that the mineral phases of prepared material are corundum, metallic aluminum and AlN respectively. The SEM investigation revealed that both tetragonal whiskers and hexagon powders of AlN were formed. The results of hydration tests indicated that the rate of weight gain and pulverization of the material were negligible and the ratio of residual crushing strength was kept at a high level. The XRD patterns of samples after hydration tests identified that the AlN phase still remained although a small amount of AlOOH and Al(OH)3 was formed due to the hydration of AlN. It is believed that the limited hydration of AlN should be contributed to the dissolution of O element to AlN. The hydration mechanism of AlN was discussed.
1133
Authors: Hua Zhi Gu, Hou Zhi Wang, Mei Jie Zhang, Ao Huang, Wen Jie Zhang
Abstract: The temperature distribution of the permeable brick was modeled using CFX software. The influence of magnesia and corundum on thermal shock resistance of non-cement bonded alumina-based permeable brick was investigated. The results indicated that, in the gas blow process, the high temperature regions near the working face of the brick gradually expanded with the increase of the gas flow rate. Therefore the inner part of the brick had the complex and large change of thermal stress. Further experiments demonstrated that thermal shock resistance of alumina-magnesia based castable refractory was better than that of alumina-chrome based castable refractory. With the increase of magnesia amount, the alumina-magnesia based castable refractory had more cycles of heating and water-cooling. When different kinds of corundum were added in the raw materials, the sample with tabular corundum showed the best thermal shock resistance, the one with white fused corundum performed worse and the one with fused dense corundum performed worst.
1152
Authors: Xi Tang Wang, Heng Zhi Wang, Wen Jie Zhang, Jia Lin Sun, Yan Ruo Hong
373
Showing 1 to 6 of 6 Paper Titles