Papers by Author: Xiao Fen Guan

Paper TitlePage

Authors: Yan Jie Zhang, Wei Guo Fu, Xiang Yun Deng, Ren Bo Yang, Zhong Wen Tan, Li Ren Han, Cheng Lu, Xiao Fen Guan
Abstract: Hysteresis loop and dielectric properties of lead-free BaTiO3-La2O3 piezoelectric ceramics and BaTiO3 ceramic compared with pure BaTiO3 has been systematically studied. The amount of La2O3 addition ranged from 0.3~0.5mol% by controlling the sintering temperature. Dielectric properties of BaTiO3-La2O3 were promoted after the addition of La2O3, the maximum value of dielectric constant reached 8,624, recently. The role of La2O3 on the solid-state sintering of BaTiO3 is discussed on the basis of the solid-solution defect model.
1222
Authors: Zhong Wen Tan, Wei Guo Fu, Xiang Yun Deng, Ren Bo Yang, Xiao Fen Guan, Cheng Lu, Yan Jie Zhang, Li Ren Han
Abstract: The(1-x)BaTi0.8Zr0.2O3-xBa0.7Ca0.3TiO3 ceramics have been prepared by sol-gel technique, where x is from 0.2 to 0.6. It reveals that the dense ceramics can be obtained when the sintered temperature is above 1250°C. It is lower than that of solid state reaction ceramics. In particular, when x=0.3, at which is near the MPB composition, the ferroelectric and piezoelectric properties are more excellent than the others. The maximum dielectric constant is above 9000, which can be observed in the butterfly shape curves of dielectric constant as a function of electric field. The maximum piezoelectric coefficient d33 can reach 400 pm/V, and it is obtained from the piezoelectric response loops.
1480
Authors: Ren Bo Yang, Wei Guo Fu, Xiang Yun Deng, Zhong Wen Tan, Yan Jie Zhang, Li Ren Han, Cheng Lu, Xiao Fen Guan
Abstract: The (Ba0.88Ca0.12)( Zr0.12Ti0.88)O3 powders and piezoelectric ceramics were prepared by sol-gel process. The reaction process was analyzed with the help of thermo gravimetric and differential scanning calorimetry. X-ray diffraction characterized results showed that the structure of the (Ba0.88Ca0.12)( Zr0.12Ti0.88)O3 powders was perovskite structure and the particle size was approximately 37nm. Piezoelectric measurements revealed that Curie temperature and the maximum piezoelectric coefficient d33 is 95°C and 215pm/V, respectively.
1062
Authors: Li Ren Han, Wei Guo Fu, Xiang Yun Deng, Xiao Fen Guan, Zhong Wen Tan, Cheng Lu, Ren Bo Yang, Yan Jie Zhang
Abstract: (Ba0.7Ca0.3)TiO3 (BCT) powders and ceramics have been prepared by sol-gel technique. Structural evolution of the BCT dry gels are investigated by thermal gravimetric analysis–differential scanning calorimetry. It is found that BCT crystallites can be formed before 800 . Well-sintered samples are synthesized at 1260 for 2h. The crystal structure of the BCT powders is studied by XRD and ferroelectric properties of the ceramics are characterized by TF analyzer 2000. The Curie temperature Tc of the BCT ceramics is at about 125 . The maximum dielectric constant (εr) reaches about 4851 at 125 and hysteresis loops are measured with the temperature range from 25 to 150 .
1016
Authors: Xiao Fen Guan, Xiang Yun Deng, Cheng Lu, Zhong Wen Tan, Yan Jie Zhang, Ren Bo Yang, Li Ren Han
Abstract: Barium zirconate titanate Ba(Ti1-yZry)O3 (BZT, y = 0.02, 0.07, 0.09, 0.12, 0.15) ceramics have been prepared by sol–gel process. All the BZTx ceramics exhibited perovskite phase detected by X-ray diffraction, and the diffraction peaks shift to lower angle with increasing the content of Zr. Dielectric susceptibilities are up to 15500, and tunability up to 74.9% under electric field 6.8 kV/cm at 100 Hz.
1091
Showing 1 to 5 of 5 Paper Titles