Papers by Author: Zhong Qiu Wang

Paper TitlePage

Authors: Dong Lu, Jian Feng Li, Yi Ming Rong, Jie Sun, Jun Zhou, Zhong Qiu Wang
Abstract: A burr formation process in micro-cutting of Al7075-T7451 was analyzed. Three stages of burr formation including steady-state cutting stage, pivoting stage, and burr formation stage are investigated. And the effects of uncut chip thickness, cutting speed and tool edge radius on the burr formation are studied. The simulation results show that the generation of negative shear zone is one of the prime reasons for burr formation. Uncut chip thickness has a significant effect on burr height; however, the cutting speed effect is minor. Unlike in conventional cutting, in micro-cutting the effect of tool edge radius on the burr geometry can no longer be neglected.
470
Authors: Zhong Qiu Wang, Jian Feng Li, Jie Sun, Feng Jiang, Jun Zhou
Abstract: In the present study, two-dimensional orthogonal slot milling experiments in conjunction with an analytical-based computer code are used to determine flow stress data as a function of the high strains, strain rates and temperatures encountered in metal cutting. By using this method, the flow stress of Al7050-T7451 is modeled. Through the comparison of cutting forces between FEM and experiment, the FEM model using predicted flow stress can give precise cutting forces. The work of this paper provides a useful method for material constitutive equation modeling without doing large number of cutting experiment or expensive SHPB tests.
174
Authors: Zhong Qiu Wang, J. Sun, Jian Feng Li, I. Al-Zkeri
Abstract: Residual stress on the machined surface and the subsurface is one of the most important factors that can influence the service quality of a component, such as fatigue life, tribological properties, and distortion. In this work, a 2D FEM model of AISI 52100 hard turning processes is setup. The material properties are widely selected to describe the material property more precisely. By using user subroutine named Konti-Cut, the steady state of cutting process is simulated and the cutting forces and residual stresses in this time are investigated. By comparing the cutting forces, the FEM model can gives quite good appliance with experimental data. And the basic relations between residual stresses and cutting parameter, tool geometry are drawn.
688
Authors: Jian Ling Chen, Jian Feng Li, Jie Sun, Zhong Qiu Wang, Zhi Ping Xu
Abstract: Johnson-Cook (JC) constitutive model is extensively used in the simulation of metal machining. There are several different sets of JC material constants for titanium alloy Ti6Al4V fitted by split-Hopkinson bar (SHPB) tests. However, few researches have been done to study their sensitivity on the behavior of cutting. In this work, four different sets of material constants were performed in a 2D numerical model to simulate the cutting process of titanium alloy Ti6Al4V. The effects of the four sets of material constants on the predicted cutting forces, chip morphology and temperature were studied. It is shown that all the considered process outputs are very sensitive to material constitutive constants. Some quantitive comparisons with experimental results reported in the literature were also made.
182
Showing 1 to 4 of 4 Paper Titles