Papers by Keyword: High Temperature Strength

Paper TitlePage

Authors: Bum Yean Cho, Heung Youl Kim, Seung Cho Yang, Seung Un Chae
Abstract: This research is to show the microstructure of fracture parts of structural steels by welding at the high temperature. Discontinuity of mechanical and chemical property at HAZ of welding parts is the cause of decreasing structure safety. Therefore, this study was determined the effect of the welding of steels through a high temperature tensile tests and fracture portion of the microstructure. The results showed that does not cause destruction until temperature reached 600°C.
397
Authors: Frank L. Riley
479
Authors: Jeoung Han Kim, Jong Taek Yeom, Nho Kwang Park, Chong Soo Lee
Abstract: The high-temperature deformation behavior of the single-phase α (Ti-7.0Al-1.5V) and α + β (Ti-6Al-4V) alloy were determined and compared within the framework of self-consistent scheme at various temperature ranges. For this purpose, isothermal hot compression tests were conducted at temperatures between 650°C ~ 950°C to determine the effect of α/β phase volume fraction on average flow stress under hot-working condition. The flow behavior of α phase was estimated from the compression test results of single-phase α alloy whose chemical composition is close to that of α phase of Ti-6Al-4V alloy. On the other hand, the flow stress of β phase in Ti-6Al-4V was predicted by using self-consistent method. The flow stress of α phase was higher than that of β phase above 750°C, while the β phase revealed higher flow stress than α phase at 650°C. Also, at temperature above 750°C, the predicted strain rate of β phase was higher than that of α phase. It was found that the relative strength between α and β phase significantly varied with temperature.
3607
Authors: Jae Cheon Ahn, Gyu Man Sim, Kyung Sub Lee
Abstract: Effects of aging treatment on high temperature strength of Nb added ferritic stainless steels for automotive parts were investigated. Hot tensile tests were carried out at 700 °C after the aging at 700 °C for different aging times using Gleeble 1500. High temperature strength of all steels decreased as the aging time increased. In Nb free steels, the reduction in high temperature strength is mainly due to grain growth. On the other hand, in Nb added steels, the reduction in high temperature strength occurred by Nb precipitation. It was observed that Fe2Nb (Laves phase), Nb(C,N) and Fe3Nb3C were precipitated out during the aging at 700 °C in Nb added steels. The coarsening rate of Fe2Nb was higher than that of Nb(C,N). Fine Fe2Nb precipitates formed during at the early stage of aging contributed to high temperature strength in 0.01C-0.38Nb steel. However, coarse Fe2Nb particles formed during the aging were very detrimental to high temperature strength. The coarsening of Fe2Nb was relatively retarded by adding Mo.
191
Authors: Xuan Liu, Qiang Xu, Shi Zhen Zhu
Abstract: ZrB2-SiC-B4C is sintered at 1700°C by spark plasma sintering process. The effect of B4C content on the mechanical properties and microstructure of ZrB2-SiC based ceramics is studied. The results show that, with the content of B4C increases, the relative density and room-temperature strength decrease in the ZrB2-SiC-B4C composite. The fracture toughness rises at first and then falls down. The high temperature strength increases.
218
Authors: Masataka Yoshikawa, R. Matsuki, Y. Habara, Hideki Aoyama
421
Showing 1 to 10 of 39 Paper Titles