Papers by Keyword: High Tensile Strength Steel Sheet

Paper TitlePage

Authors: Seung Chul Shin, Sung Mo Yang, Hyo Sun Yu, Hee Yong Kang, Chae Won Kim
Abstract: This paper shows how the number of lap of spot welded joints in automotive steel sheets changes the life -cycle transform of itself. There has been significant developments in the life extension of automotive steel sheets, as well as in passenger safety. We verified the validity of the S-N curve of materials by QSTS test. Moreover, we used EZNCEN and HS40R, which are commonly used as automotive steel sheets because of their excellence in increasing fuel efficiency. The purpose of research was to compare the fatigue life of multi - lap of spot welded joints to there. In addition s, we used the two different kinds of sheets together in the same welding under the same condition. Through this whole process, the hypothesis on the life cycle of lethargy coefficients was found to be in good agreement with the result of the experiment. That is, when using sheets of the same materials in one welding, the fatigue life of two laps of a spot welded joint was found to be much superior by EZNCEN 5~14%, HS40R 17~30%,and when using each sheet of different materials, we found the decrease in fatigue life by 6~16%. Finally, the best value from the data was chosen based on the experiment for the analysis of the fatigue life of each layer.
151
Authors: Takeshi Uemori, Hiroshi Miyake, Tetsuo Naka, Michihiro Takiguchi, Fusahito Yoshida
Abstract: The framework for the complex step derivative approximations (hereafter CDSA) to calculate the consistent tangent moduli is studied. The present methods is one of the most effective methods to implement any material constitutive equations to the commercial finite element codes and does not suffer from calculation conditions and errors. In order to confirm the efficiency of CDSA, we developed the user subroutine code based on the CDSA using associative J2 flow rules with general nonlinear isotropic hardening rules that is commonly and widely utilized in commercial finite element codes. In this study, the user material subroutine ‘Hypela2’ of MSC.Marc (ver.2013.0.0) was utilized. The finite element calculation result by the proposal method shows a good agreement with the corresponding result by the MSC.Marc default setting. Also we apply the Yoshida-Uemori back stress model to the CDSA and evaluate this new technique to predict the deformation behavior of high tensile strength steel sheet.
187
Authors: Takeshi Uemori, T. Kuramitsu, Ryutaro Hino, Tetsuo Naka, Fusahito Yoshida
Abstract: This paper deals with experimental observations and modeling of plastic deformations of a high strength steel sheet (HSS sheet) under biaxial stress conditions. Using a cruciform specimen of a HSS sheet of 980MPa-TS, experiments of proportional and non-proportional loadings were performed. Numerical simulations for the biaxial stress-strain responses were conducted using a constitutive model of large-strain cyclic plasticity (Yoshida-Uemori model), and the results were compared to the experimental data. The results of numerical simulation show a good agreement with the experimental results, which is attributed to accurate modeling of the backstress evolution of the anisotropic yield surface.
895
Showing 1 to 3 of 3 Paper Titles