Papers by Keyword: Slow Strain Rate Test (SSRT)

Paper TitlePage

Authors: Seong Jong Kim, Seok Ki Jang, Jeong Il Kim
Abstract: The electrochemical and mechanical properties of welded high-strength steel were investigated using the slow strain rate test method with a constant applied cathodic potential. No correlations were found with the maximum tensile strength, yield strength, stress at failure, or hydrogen embrittlement. However, the elongation, time-to-fracture, and strain-to-failure ratio decreased as the potential became more negative. These parameters were greatest when the potential was -770mV, regardless of the post-weld heat treatment conditions. The elongation and time-to-fracture increased with PWHT.
133
Authors: Li Zhang, Wen Long Xu, Tai Man Yue
Abstract: Laser surface melting (LSM) of aluminum alloy 6013 was conducted using a high power Nd-YAG laser under nitrogen gas with the aim of improving the stress corrosion cracking (SCC) resistance of the alloy. The SCC behavior was studied in a 3.5% NaCl solution using a slow strain rate test (SSRT). A laser-melted layer in the order of 500µm thick was produced, which consists of fine dendritic and cellular structures with some Al-Si-Cu-Fe-Mn phase particles formed at interdentritic boundaries. The results of the SSRT test showed that the susceptibility of the alloy to SCC, in terms of total elongation to failure, was decreased after the laser surface modification. This was considered to be attributed to the presence of the laser-formed AlN film, which acted as a barrier to the ingress of the corrosive Cl- into the material and enhanced the pitting resistance of the material. An examination of the fractured surface indicated that the crack propagation path, in the early stage of SCC, was along the tortuous dendrite and cell boundaries. This caused the crack path deviated from the growing direction and resulted in a longer crack length covered before failure thus increasing the overall crack propagation resistance.
1047
Authors: S. Rangarajan, Douglas Shukert, Yo-ichi Takeda, K. Sakaguchi, Tetsuo Shoji
993
Authors: Maria J. Correia, Manuela M. Salta
Abstract: The corrosion resistance under mechanical stress can be one of the most concerning types of localized corrosion for the application of stainless steel reinforcements in concrete. This paper will assess the stress corrosion cracking susceptibility, by the slow strain rate test method (SSRT), of three austenitic stainless steel alloys: one conventional Fe-Cr-Ni base alloy and two new composition Fe-Cr-Mn base alloys adequate to the manufacturing of ribbed bars for reinforcing concrete. The SSRT results show that only one of the austenitic Fe-Cr-Mn alloys is susceptible to stress corrosion cracking while the other shows a performance similar to that of the AISI 304 stainless steel alloy.
1511
Authors: Jae Kyoo Lim, Tetsuo Shoji, J.W. Who, Se Hi Chung, H. Takahashi
113
Showing 1 to 5 of 5 Paper Titles