Papers by Keyword: Tool Wear Mechanisms

Paper TitlePage

Authors: P.K. Mehrotra
1
Authors: Rajesh Patil, Vilas Kalamkar, Hari Vasudevan
Abstract: Heat generated in machining is significant to study, as number of technical and economic problems has root into it. The high temperatures on cutting tool needs better understanding of contact processes at tool-chip ,tool-workpiece interfaces. The contact length at tool-chip interface is significant to study as it governs the heat moving to the tool as well as many tribological conditions like stresses, tool wear. Understanding of Tool-workpiece interface is significant as it affects the heat moving to workpiece, tool, chip as well as tool flank wear and major machined surface characteristics. Non-sliding type tool wear mechanisms which are highly sensitive to temperature changes are important to study. The latest trends of using High Speed Machining, Dry and Near Dry Machining, Finish hard turning results in more heat generation demanding significant understanding of effect of heat generated and temperatures.
1550
Authors: Takeshi Miyamoto, Junsuke Fujiwara, Keisuke Wakao
Abstract: In this study, turning of the cemented carbides that their WC particle size was standardized were carried out with the PCD and the cBN tools. The WC particle diameter of cemented carbides was about 2µm and the Co contents were 10, 15, 20 and 25%, respectively. The influence of the WC particle size and Co contents was investigated. Summary of results are shown as follows: (1) In turning with the PCD tool, the more the Co contents increase, the more the tool wear increases. (2) In turning with the cBN tools, the more the Co contents of the work material increase, the more the tool wear decreases. (3) In turning of the cemented carbides contained the larger quantity of Co, the cBN tools are more effective than the PCD tool.
428
Authors: Jin Xing Kong, Liang Li, Dong Ming Xu, Ning He
Abstract: Pure iron is a kind of high plasticity and toughness material. In the process of cutting pure iron, the tool wear is very serious. In this paper, three kinds of cutting tools KC5010, K313 and 1105 are used in the cutting pure iron process and the tool wear tests in dry cutting condition with different cutting parameters have been carried out. According to the results, the tool wear mechanisms and tool life of three kinds of cutting tools have been compared and analyzed. It is concluded that the tool life of K313 is better than KC5010 and 1105 and the three kinds of tool mechanisms are primarily adhesion wear, diffusion wear and oxidation wear.
74
Showing 1 to 4 of 4 Paper Titles