Papers by Keyword: Epitaxial Graphene

Paper TitlePage

Authors: Bilal Jabakhanji, Nicolas Camara, Alessandra Caboni, Christophe Consejo, Benoit Jouault, Philippe Godignon, Jean Camassel
Abstract: We present the growth and characterization of epitaxial Graphene on the (000-1) and (11-20) planes. In both cases, the growth was carried out in a RF furnace, by implementing our technique of confined atmosphere, covering the SiC substrate with a graphitic cap during the growth. The grown material was investigated by means of AFM, SEM, Raman spectroscopy and magneto transport. Contrary to the (0001) face, in both faces (000-1) and (11-20), almost free standing Graphene monolayers of very high quality are grown. These Graphene sheet are uniform, continuous, almost strain-free and lightly doped. In both faces, Hall bars were fabricated and Shubnikov-de Haas oscillations typical of Graphene, as well as the Half Integer Quantum Hall Effect are observed.
Authors: Felix Fromm, Martin Hundhausen, Michl Kaiser, Thomas Seyller
Abstract: Raman spectroscopy is commonly applied for studying the properties of epitaxial graphene on silicon carbide (SiC). In principle, the Raman intensity of a single graphene layer is rather low compared to the signal of SiC. In this work we follow an approach to improve the Raman intensity of epitaxial graphene on SiC by recording Raman spectra in a top-down geometry, i.e. a geometry in which the graphene layer is probed with the excitation through the SiC substrate [1]. This technique takes advantage of the fact, that most of the Raman scattered light of the graphene is emitted into the SiC substrate. We analyze in detail the top-down measurement geometry regarding the graphene and SiC Raman intensity, as well as the influence of aberration effects caused by the refraction at the air/SiC interface.
Authors: A. Oliveros, Camilla Coletti, Christopher L. Frewin, Christopher Locke, Ulrich Starke, Stephen E. Saddow
Abstract: An ever-increasing demand for biocompatible materials provides motivation for the development of advanced materials for challenging applications ranging from disease detection to organ function restoration. Carbon-based materials are considered promising candidates because they combine good biocompatibility with high chemical resistance. In this work we present an initial assessment of the biocompatibility of epitaxial graphene on 6H-SiC(0001). We have analyzed the interaction of HaCaT (human keratinocyte) cells on epitaxial graphene and compared it with that on bare 6H-SiC(0001). We have found that for both graphene and 6H-SiC there is evidence of cell-cell and cell substrate interaction which is normally an indication of the biocompatibility of the material.
Authors: Jawad ul Hassan, Chariya Virojanadara, Axel Meyer, Ivan G. Ivanov, Jan I. Flege, Somsakul Watcharinyanon, Jens Falta, Leif I. Johansson, Erik Janzén
Abstract: We report graphene thickness, uniformity and surface morphology dependence on the growth temperature and local variations in the off-cut of Si-face 4H-SiC on-axis substrates. The transformation of the buffer layer through hydrogen intercalation and the subsequent influence on the charge carrier mobility are also studied. A hot-wall CVD reactor was used for in-situ etching, graphene growth in vacuum and the hydrogen intercalation process. The number of graphene layers is found to be dependent on the growth temperature while the surface morphology also depends on the local off-cut in the substrate and results in a non-homogeneous surface. Additionally, the influence of dislocations on surface morphology and graphene thickness uniformity is also presented.
Authors: Viktoria Eless, Rositza Yakimova, Ruth Pearce
Abstract: Silicon carbide (SiC) is a well-known material for UV detection however the effect of UV illumination on the electron donation between the substrate, interfacial (or buffer layer) and graphene is not well understood. The effect of ultraviolet (UV) illumination on the carrier concentration of an epitaxial graphene hall bar device is investigated by scanning Kelvin probe microscopy (SKPM) and transport measurements in ambient and vacuum conditions. Modulation of the carrier concentration is demonstrated and shown to be due to both substrate and environmental effects.
Authors: Ruth Pearce, R. Yakimova, Jens Eriksson, L. Hultman, Mike Andersson, Anita Lloyd Spetz
Abstract: Epitaxially grown single layer graphene on silicon carbide (SiC) resistive sensors were characterised for NO2 response at room and elevated temperatures, with an n-p type transition observed with increasing NO2 concentrations for all sensors. The concentration of NO2 required to cause this transition varied with different graphene samples and is attributed to varying degrees of substrate induced Fermi-level pinning above the Dirac point. The work function of a single layer device demonstrated a steady increase in work function with increasing NO2 concentration indicating no change in reaction mechanism in the concentration range measured despite a change in sensor response direction. Epitaxially grown graphene device preparation is challenging due to poor adhesion of the graphene layer to the substrate. A field effect transistor (FET) device is presented which does not require wire bonding to contacts on graphene.
Authors: Nicolas Camara, Alessandra Caboni, Jean Roch Huntzinger, Antoine Tiberj, Narcis Mestres, Phillippe Godignon, Jean Camassel
Abstract: Epitaxial graphene growth is significantly different depending on the polarity of the 6H-SiC surface: Si- or C-face. On the Si-face, a uniform coverage of few layers on the whole sample can be obtained, but with electrical properties disturbed by the presence of a Carbon-rich buffer layer at the interface. On the contrary, on the C-face, we demonstrated that almost free-standing very large monolayers of graphene can be obtained by covering the sample with a graphitic cap during the growth.
Authors: Sebastian Roensch, Stefan Hertel, Sergey A. Reshanov, Adolf Schöner, Michael Krieger, Heiko B. Weber
Abstract: The electrically active deep levels in a graphene / silicon carbide field effect transistor (FET) were investigated by drain-current deep level transient spectroscopy (ID-DLTS). An evaluation procedure for ID-DLTS is developed in order to obtain the activation energy, the capture cross section and the trap concentration. We observed three defect centers corresponding to the intrinsic defects E1/E2, Ei and Z1/Z2 in n-type 6H-SiC. The determined parameters have been verified by conventional capacitance DLTS.
Authors: Toby Hopf, Konstantin Vassilevski, Enrique Escobedo-Cousin, Peter King, Nicholas G. Wright, Anthony G. O’Neill, Alton B. Horsfall, Jonathan Goss, George Wells, Michael Hunt
Abstract: Top-gated field-effect transistors have been created from bilayer epitaxial graphene samples that were grown on SiC substrates by a vacuum sublimation approach. A high-quality dielectric layer of Al2O3 was grown by atomic layer deposition to function as the gate oxide, with an e-beam evaporated seed layer utilized to promote uniform growth of Al2O3 over the graphene. Electrical characterization has been performed on these devices, and temperature-dependent measurements yielded a rise in the maximum transconductance and a significant shifting of the Dirac point as the operating temperature of the transistors was increased.
Authors: Filippo Giannazzo, Stefan Hertel, Andreas Albert, Antonino La Magna, Fabrizio Roccaforte, Michael Krieger, Heiko B. Weber
Abstract: Epitaxial graphene fabricated by thermal decomposition of the Si-face of silicon carbide (SiC) forms a defined interface to the SiC substrate. As-grown monolayer graphene with buffer layer establishes an ohmic interface even to low-doped (e. g. [N] ≈ 1015 cm-3) SiC, and a specific contact resistance as low as ρC = 5.9×10-6 Ωcm2 can be achieved on highly n-doped SiC layers. After hydrogen intercalation of monolayer graphene, the so-called quasi-freestanding graphene forms a Schottky contact to n-type SiC with a Schottky barrier height of 1.5 eV as determined from C-V analysis and core level photoelectron spectroscopy (XPS). This value, however, strongly deviates from the respective value of less than 1 eV determined from I-V measurements. It was found from conductive atomic force microscopy (C-AFM) that the Schottky barrier is locally lowered on other crystal facets located at substrate step edges. For very small Schottky contacts, the barrier height extracted from I-V curves approaches the value of 1.5 eV from C-V and XPS.
Showing 1 to 10 of 47 Paper Titles