Paper Titles
Effect of SiC Powder Characteristic on the Rheological Properties of Feedstock
p.994
Simulation of Ceramic Injection Molding for Zirconia Optical Ferrule
p.997
Superplastic Deformation of Nano-Sized α-Sialon Ceramics
p.1001
Forming of Large Thin Walled Fused Silica Shapes by Gelcasting
p.1005
Study on Processing Parameters of Ceramic Injection Moulding
p.1009
A New Dewaxing Method and its Effect on the Properties of Low-Pressure Injection Molded Ceramics
p.1012
Injection Molding of Zirconia Ceramics Using Water-Soluble Binder
p.1017
The Influences of Solid Loading and Molding Variables on Alumina Injection Molding
p.1021
On the Defects in Injection-Moulded Technical Ceramics
p.1025

Study on Processing Parameters of Ceramic Injection Moulding

Article Preview

Abstract:

According to the heat transmission theory, in the aid of computer, the temperature distribution in the cylinder cavity was calculated. The temperature of the mould has much influence on the time for the injection material’s temperature of the cavity center to drop to the injection material softening temperature. The influence of the processing parameters on the density of the injection molding specimens was also investigated. It turns that the injection molding specimens’ density changes little with the increase of injection temperature and pressure, but changes a lot with the increase of holding pressure time.

You might also be interested in these eBooks
High-Performance Ceramics IV View Preview

Info:

Periodical:

Key Engineering Materials (Volumes 336-338)

Pages:

1009-1011

DOI:

https://doi.org/10.4028/www.scientific.net/KEM.336-338.1009

Citation:

Cite this paper

Online since:

April 2007

Authors:

Xin Gang Yu, Yan Bin Zuo, Yi Gong, Zhi Peng Xie, Lan Yun Liu, Jin Long Yang, Jian Bao Li, Yong Huang, Lin Wang

Keywords:

Injection Molding, Injection Parameter

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2007 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

References

[1] J. G. Zhang, M. J. Edirisinghe and J. R. G. Evans: Industrial Ceramics Vol. 9 (1989), p.72.

Google Scholar

[2] P. S. Allan, M, J. Bevis, M. J. Edirisinghe, J. R. G. Evans, P. R. Hornsby: J. Mater. Sci. Lett. Vol. 6 (1987), p.165.

Google Scholar

[3] J. A. Mangels and R. M. Williams: Ceramic Bulletin Vol. 62 (1983), p.601.

Google Scholar

[4] T. Zhang: PH. D Thesis, Tsinghua University, (1988).

Google Scholar

[5] Z.P. Xie: PH. D Thesis, Tsinghua University, (1993).

Google Scholar

[6] X.G. Yu and L. Wang: Bulletin of the Chinese Ceramic Society Vol. 5 (1997), p.55. Fig. 4 The variation of injection moulded cylinder's density with the hold pressure time.

Google Scholar