Paper Titles
Precision Machining of Si3N4 Refrigerator Friction Couple Based on FEA
p.1451
Grinding of TZP/Al2O3 Composite with Vitrified CBN Wheels
p.1455
High Speed Lapping of SiC Ceramic Material with Fixed Abrasive
p.1458
Micro Groove Machining Characteristics of Si3N4-hBN Composites
p.1461
Wear Characteristics of Twist Drills in Machining Fluorophlogopite
p.1465
Surface Behaviors of ELID Ground Engineering Ceramics
p.1469
In-Process Electrolytic Dressing Lapping (IEDL) of Al2O3-BN Machinable Ceramics
p.1473
Fabrication of SiCN MEMS by UV Lithography of Polysilazane
p.1477
Thermodynamic Properties of Gangue
p.1481

Wear Characteristics of Twist Drills in Machining Fluorophlogopite

Article Preview

Abstract:

The machinable fluorophlogopite was drilled with tungsten-cobalt carbide and high-speed steel drill bits, respectively. The wear widths of major flank were measured, and the wear characteristic of twist was analyzed during drilling fluorophlogopite ceramics.Drilling experiments were carried to consider influence factors of drill bit wear, such as tool materials, cooling condition, spindle speed and tool angles. Tool materials and cooling conditions are the major factors to affect wear of drill bits. High-speed steel drill bits are not suitable for drilling fluorophlogopite ceramics. Cooling condition affects wear remarkably. With the rising of spindle speed, the wear widths of major flank grows. But apex angle has little affects on the tool wear rate. Research results indicate that low tool wear can be obtain through optimizing tool material and machining parameters in drilling fluorophlogopite ceramics.

You might also be interested in these eBooks
High-Performance Ceramics IV View Preview

Info:

Periodical:

Key Engineering Materials (Volumes 336-338)

Pages:

1465-1468

DOI:

https://doi.org/10.4028/www.scientific.net/KEM.336-338.1465

Citation:

Cite this paper

Online since:

April 2007

Authors:

L.J. Ma, Ai Bing Yu, Z.M. Mei

Keywords:

Drilling, Fluorophlogopite, Machinable Ceramics, Wear

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2007 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

References

[1] L.J. Ma, A.B. Yu, J.H. Han and J.C. Liu: Bull. of the Chin. Ceram. Soc., Vol. 23 (2004), p.106.

Google Scholar

[2] D.G. Grossman: J. Am. Ceram. Soc., 1972, 55(9), p.446.

Google Scholar

[3] Y.L. Li, G.J. Qiao, and Z.H. Jin: J. of Inor. Mater., Vol. 16 (2001), p.207.

Google Scholar

[4] L.J. Ma, A.B. Yu and Y.F. Tan: Key Engineering Materials, Vol. 280~283(2005): p.1083.

Google Scholar

[5] Z.H. Zhou: Metal Cutting Principle (Shanghai Scientific & Technical Publishers, China 1993). (in Chinese).

Google Scholar