An Accurate Method for Calculating Load Distribution Factor Kβ of Involute Gears

D.C. Feng

doi:10.4028/www.scientific.net/KEM.339.458

Paper Titles

Modeling of Piezoelectric Actuator Based Nano-Positioning System Using Multi-Polynomial Regression with C¹ Continuity
p.434

A Novel Architecture for Compiled-Type Software CNC System
p.442

VSPDT: An Optimizer for Single Point Diamond Turning
p.447

Simulation of Solid-Liquid Two-Phase Flow Inside and Outside the Abrasive Water Jet Nozzle
p.453

An Accurate Method for Calculating Load Distribution Factor K_β of Involute Gears
p.458

Effect of Nanostructured TiH₂ on the Formation of Multimeshworked and Nanoporous TiO₂ by Cathodic-Anodization Treatment
p.463

A Simple Detachment Method for Fabricating a Polymer Nanotemplate Structure
p.469

Fabrication of 3-Dimensional Microstructures Using Dynamic Image Projection
p.473

Amplification Ratio and Stiffness of Bridge-Type Flexure Hinge
p.479

HomeKey Engineering MaterialsKey Engineering Materials Vol. 339An Accurate Method for Calculating Load...

An Accurate Method for Calculating Load Distribution Factor K_β of Involute Gears

Abstract:

A new method is given to determine the load distribution factor Kβ of involute gears. Compared with the old method, the new one gives up some improper assumptions such as linear load distribution along gear tooth width. While considering the effects of bearing deformations, gear manufacture and assembly errors, gear axial force and gear tooth run-in on Kβ, the paper calculates Kβ according to “Load- Deformation Coordination” of gear tooth. Practical examples show that this method is more accurate, more effective than old ones.