5-Axis Tool Positioning via RFIM Strategy

Dan Wang; Wu Yi Chen; Rui Qiu Wang

doi:10.4028/www.scientific.net/AMM.10-12.874

Paper Titles

Laser Sintering of Reconstituted Nanostructured PSZ Feedstock Powders
p.855

The Development of Virtual Machining System Based on ACIS
p.860

Simulation of Substrate Temperature Distribution in Diamond Films Growth on Cemented Carbide Inserts by Hot Filament CVD
p.864

State Recognition Technology and Application on Milling Tool Wear
p.869

5-Axis Tool Positioning via RFIM Strategy
p.874

Cutting Parameters Optimization by Using Particle Swarm Optimization (PSO)
p.879

An Intelligent Optimization Controller for a Non-Linear System: Application to an Injection Molding Machine
p.884

Survey on the Design and Planning of Cable Harness Assemblies in Electromechanical Products
p.889

Position Control System Design and Low Speed Analysis of the Three-Axis Simulator
p.894

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vols. 10-125-Axis Tool Positioning via RFIM Strategy

5-Axis Tool Positioning via RFIM Strategy

Abstract:

A new strategy for 5-axis NC machining called Rotate-For-Intersect Machining (RFIM) was presented in this paper. The cutter was settled by two cutter contact points and in order to obtain optimized tool position and orientation, grid point method and bi-section method ware utilized in searching cutter’s rotate angle and tilt angle. Finally the algorithm was implemented on UG platform following further development and the effectiveness of the method was validated.