Paper Titles
Photoelastic Investigation of Friction and Residual Stress in Shrink-Fitted Shafts and Hubs
p.171
Development of Metallic Digital Strain Gauges
p.179
Detecting Damage in Graphite/Epoxy Composites Using Impedance-Based Structural Health Monitoring
p.185
The Use of Fibre Optic Sensors for Damage Detection and Location in Structural Materials
p.191
Development of a Temperature Calibration Device for Thermoelastic Stress Analysis
p.197
Load Cell Ringing in High Rate Compression Tests
p.205
Measurement of Material Properties for Metal Foam Cored Polymer Composite Sandwich Construction
p.211
High Strain Rate Tensile and Compressive Testing of Braided Composite Materials
p.217
Bearing Load Measurements on a 3-Shaft Gas Turbine
p.225

Development of a Temperature Calibration Device for Thermoelastic Stress Analysis

Article Preview

Abstract:

A means of calibrating the effect of temperature on the thermoelastic signal obtained from the Deltatherm system is described. A design of a suitable calibration device is covered and sample results presented and discussed.

You might also be interested in these eBooks
Advances in Experimental Mechanics View Preview

Info:

Periodical:

Applied Mechanics and Materials (Volumes 1-2)

Pages:

197-204

DOI:

https://doi.org/10.4028/www.scientific.net/AMM.1-2.197

Citation:

Cite this paper

Online since:

September 2004

Authors:

Janice M. Dulieu-Barton, S. Quinn, C. Eyre, P.R. Cunningham

Keywords:

Calibration, Deltatherm, SPATE, Thermoelastic Stress Analysis, TSA

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2004 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

References

[1] J.M. Dulieu-Barton and P. Stanley, Journal of Strain Analysis, Vol. 33 (1998) 93-104.

Google Scholar

[2] J.M. Dulieu-Smith, Strain, Vol. 31 (1995) 9-16.

Google Scholar

[3] J.R. Lesniak, B.R. Boyce and B.I. Sandor, Thermographic stress analysis/NDE via focal plane array detectors (NASA Contract Report CR-NASA-19262, 1991).

Google Scholar

[4] M.C. Fulton, Advanced topics in thermoelastic stress analysis (PhD thesis, University of Liverpool, 1998).

Google Scholar

[5] J.M. Dulieu-Smith, Development and application of thermoelastic stress analysis (PhD thesis, University of Manchester, 1993).

Google Scholar

[6] S. Quinn, Thermoelastic stress analysis of oblique holes in flat plates and cylinders (PhD thesis, University of Liverpool, 2000).

Google Scholar

[7] J.A. Jamieson, R.H. McFee, G.N. Plass, R.H. Grube and R.G. Richards, Infrared Physics and Engineering (McGraw-Hill, 1963).

Google Scholar

[8] A.S. Kobayashi (Ed), Handbook on experimental mechanics (Prentice-Hall International, 1987).

Google Scholar

[9] J.V. Nicholas and D.R. White, Traceable Temperatures (Wiley, 2001, second edition).

Google Scholar

[10] J.M. Dulieu-Barton and P. Stanley, Experimental Mechanics, Vol. 37 (1997) 440 - 444.

Google Scholar