Effect of Stabilised ZrO2, Al2O3 and TiO2 on Sintering of Hydroxyapatite

Article Preview

Abstract:

In this work, the hydroxyapatite was prepared from cortical bone after calcination at 700°C during 1 hour. In order to improve mechanical properties of HA, 5 wt% of the ZrO2 (stabilized with 12.0 wt% CeO2), Al2O3 and TiO2 were added to HA powder as a reinforcing phase. All the powders were sintered at 1300°C for 2 hours. The XRD was utilized to identify the phases composition. It was found that the initial calcined powder is hydroxyapatite with the following chemical composition Ca5(PO4)3OH. In addition, the phenolphthalein test has put into evidence the existence of free CaO. For powders containing ZrO2, the XRD spectra has showed a little percent of formed b-tricalcium phosphate (b-TCP); the HA was decomposed to (b-TCP) and CaO which forms with ZrO2 the calcium zirconate (CaZrO3). Nevertheless, in powders containing TiO2, the XRD spectra showed that a partial decomposition of HA to b-TCP was occurred with formation of calcium titanium oxide (CaTiO3). However, for powders containing Al2O3, a nearly full decomposition of HA to b-TCP was occurred, the free Al2O3 was present. Finally, it has been found that HA composites containing a large amount of b-tricalcium phosphate are resorbale than HA composites containing a small amount of b-TCP and they were not well densified. The microhardness values of HA- ZrO2 composites were greater than those of HA- Al2O3 and HATiO2 composites.

You might also be interested in these eBooks

Info:

Periodical:

Materials Science Forum (Volumes 492-493)

Pages:

241-248

Citation:

Online since:

August 2005

Export:

Price:

Permissions CCC:

Permissions PLS:

Сopyright:

© 2005 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

[1] L. L. Hench: J. Am. Ceram. Soc. Vol. 74 (1991), p.1487.

Google Scholar

[2] L. L. Hench and J. Wilson: An Introduction of Bioceramics (World Scientific Publishing Co, 1993).

Google Scholar

[3] J. Huaxia, P.M. Marquis: J. Mater. Sci. Vol. 28 (1993), p. (1941).

Google Scholar

[4] Y.M. Kong, S. Kim, H.E. Kim: J. Am. Ceram. Soc. Vol. 82 (1999), p.2963.

Google Scholar

[5] R. Ramachandra Rao, T.S. Kannan: Mater. Sci. Eng. Vol. 20 (2002), p.187.

Google Scholar

[6] V. V. Silva, F. S. Lameiras and R. Z. Domingues: Comput. Sci. Technol. Vol. 61 (2001), p.301.

Google Scholar

[7] E. Champion, S. Gautier, and D. Bernache-Assollant: J. Mater. Sci.: Mater. Med. Vol. 7 (1996), p.125.

Google Scholar

[8] J. Li, B. Fartash, and L. Hermansson: Vol. 16 (1995), p.417.

Google Scholar

[9] Wafa I. Abdel Fattah and Hanan H. Beherei: The Sixth Conference and Exhibition of the European Ceramic Society, Vol. 2 (1999), p.545.

Google Scholar

[10] Kyung- Sik Oh, Florence Caroff, Roger Famery, Marie- Francoise Sigot- Luizard and Philippe Boch: J. Eur. Ceram. Soc. Vol. 18 (1998), p. (1931).

DOI: 10.1016/s0955-2219(98)00132-0

Google Scholar

[11] H. W. Kim, Y. J. Noh, Y. H. Koh, H. Ee Kim and H. M. Kim: Biomaterials Vol. 23 (2002), p.4113.

Google Scholar

[12] R. B. Heimann and T. A. Vu: J. Mater. Sci. Lett. Vol. 16 (1997), p.437.

Google Scholar

[13] J. M. Wu and T. S. Yeh: J. Mater. Sci. Vol. 23 (1988), p.3771.

Google Scholar

[14] H. W. Kim, Y. H. Koh, S. B. Seo and H. Ee Kim: Mater. Sci . Eng. Vol. 23 (2003), p.515.

Google Scholar

[15] M. Jarcho: Clin. Ortho. Rel. Res. June (1981), p.259.

Google Scholar

[16] C. P. A. T. Klein, A. A. Driessen, K. DeGroot, and A. Van den Hoff, J. Biomed. Mater. Res., Vol. 17 (1983), p.769.

Google Scholar

[17] L. L. Hench, J. Am. Ceram. Soc., Vol. 81 (1998), p.1705.

Google Scholar