Papers by Author: Bahman Azarhoushang

Abstract: Generally in the grinding of modern aviation materials such as nickel-based superalloys, problems frequently occur in terms of burr formation, profile loss of the wheel, high heat generation in the contact zone, high grinding forces as well as low process reliability. A recent and promising method to overcome these technological constraints is the use of ultrasonic assistance, where high-frequency and low amplitude vibrations are superimposed on the movement of the workpiece. This paper presents the design of an ultrasonically vibrated block sonotrode and the experimental investigation of ultrasonically assisted profile grinding of Inconel 718. The profile wear, radial wear of the wheel, grinding forces and surface roughness by ultrasonic-assisted and conventional profile grinding were measured and compared. The obtained results show that the application of ultrasonic vibration can decrease the radial wear of the wheel, profile wear, grinding forces and surface roughness considerably.

Abstract: The application of advanced ceramics in high-tech industries is increasing considerably due to their superior properties. However the difficulties involved and manufacturing costs have been impediments to the widespread replacement of metals by the advanced ceramics. One of the main targets in grinding of these materials is increasing the machining efficiency while preserving the surface integrity. Hence in order to reduce the grinding forces and temperatures and increase the material removal rate, a specially designed segmented wheel (T-Tool) has been developed. Reducing the static cutting edges via segmenting the wheel which automatically leads to reduction of momentarily engaging cutting edges results in a reduction of rubbing and plowing regimes and therefore a decrease in the specific grinding energy. The obtained results show that the application of the T-Tool wheel can increase the G-ratio and decrease the grinding forces considerably. A decrease of up to 35% of grinding forces has been achieved.

Abstract: The total removal of grinding wheel material includes two main parts. The larger of the two is the result of dressing and truing operation and the other relatively small part is due to the wheel wear which takes place during the actual grinding process. The frequency of dressing and truing operations depends on the cutting conditions, wheel characteristic, etc. However in dry grinding as there is no cutting fluid to transfer the heat from the contact zone, the wheel wear during grinding and the frequency of dressing is much higher due to the higher grinding forces and temperatures. Vibration grinding reduces wear of the grinding wheel during the process considerably and decreases the frequency of dressing operation significantly. Hence it increases the efficiency of the process and reduces the cost. The investigation carried out in the KSF institute shows the improvement on the surface roughness, reduction of the grinding forces, thermal damage of the ground surface and radial wear of the grinding wheel in case of using vibration grinding comparing to conventional grinding. The designed and developed ultrasonically vibrated workpiece holder and the experimental investigation show a decrease of up to 80% of radial wear of the grinding wheel.

Abstract: Compared to other machining processes, conventional grinding has a low material removal rate and involves high specific energy. A major part of the specific energy in grinding is changed to heat which makes harmful effect on surface quality. A recent and promising method is the use of ultrasonic assistance to increase the material removal rate along with decreasing the thermal damage on the workpiece and reducing cutting forces. The advantages of Ultrasonic Assisted Grinding (UAG) were proved mostly for the brittle material. Our investigations show the improvement on the surface roughness, reduction of the grinding forces and thermal damage in case of using UAG comparing to Conventional Grinding (CG) for a soft material of 100Cr6. The designed and developed ultrasonically vibrated workpiece holder and the experimental investigation show a decrease of up to 40% of normal grinding forces.