Papers by Author: Gregor Stengel

Abstract: The prototype for the flying cutting of spatially curved extrusion profiles developed as part of the Collaborative Research Center Transregio 10 (SFB/TR 10) was tested as an integrated part of the overall system in first test runs. The profiles resulting from this process give proof of the potential involved in both, the novel curved profile extrusion (CPE) and the automatic supporting and cutting device. For subsequent automated processing to become possible, however, the reliably achievable accuracy of extruded profiles needs to be further improved. By the example of the extruded profiles produced so far, this article discusses potential factors that may impair profile accuracy and presents approaches and methods for the improvement of accuracy.

Abstract: The innovative process of curved profile extrusion facilitates the cost-effective production of lightweight structures with spatially curved profiles even for small series. Due to the extrusion process a continuous flow of material is unavoidable. The profiles have to be separated reactionlessly during the extrusion following the complex trajectory of the cut-off point in space. This paper discusses the challenges for a flying cut-off device. In addition to a concept to generate the trajectories and control the movements, the main parameters for dimensioning a cut-off device are presented. A specially designed clamping device permits to generate high accelerations. Further on, cutting results are shown especially for extruded sections with continuous reinforcing elements of steel.