Papers by Author: J. Huétink

Abstract: In this paper, a numerical problem with contacting solid metal flows is presented and solved with an arbitrary Lagrangian-Eulerian (ALE) finite element method. The problem consists of two domains which mechanically interact with each other. For this simulation a new free surface boundary condition is implemented for remeshing of the boundary elements. It uses explicitly that the integral of the convective velocity along a boundary element remains zero. Steady state solutions are obtained only if the integral of the convective velocities along each free surface boundary element remains zero. The new remeshing option for the free surface is tested on a cladding problem employing friction stir welding (FSW). The problem describes two elasto-viscoplastic aluminum material flows which mechanically interact.

Abstract: The Coulomb friction model is frequently used for sheet metal forming simulations. This model incorporates a constant coefficient of friction and does not take the influence of important parameters such as contact pressure or deformation of the sheet material into account. This article presents a more advanced friction model for large-scale forming simulations based on the surface changes on the micro-scale. When two surfaces are in contact, the surface texture of a material changes due to the combination of normal loading and stretching. Consequently, shear stresses between contacting surfaces, caused by the adhesion and ploughing effect between contacting asperities, will change when the surface texture changes. A friction model has been developed which accounts for these microscopic dependencies and its influence on the friction behavior on the macro-scale. The friction model has been validated by means of finite element simulations on the micro-scale and has been implemented in a finite element code to run large scale sheet metal forming simulations. Results showed a realistic distribution of the coefficient of friction depending on the local process conditions.

Abstract: Even though Extrusion is often regarded as a semi stationary process, the defor- mations of the die at the beginning of the process can have great influence on the process later on. During filling of the die, the deformation of the die depends on the location of the flow front up to a point where parts of the profile will be opened or closed, especially in porthole dies. In this paper we present an accurate 2D method to simulate the filling of extrusion dies. The method is based on the pseudo concentration technique. We compare different options to model the pseudo material and choose the best.

Abstract: This paper presents the effect of combined stretching and bending on the achieved strain in incremental sheet forming ISF. A simple two dimensional model of strip undergoing stretching and travelling three point bending in cyclic form is used. The numerical model presents the effect of the ratio of stretching velocity to roll-set speed on the achieved strain and its distribution.

Abstract: The accuracy of material models can have a large impact on the overall accuracy of material forming simulations in general and sheet forming simulations in particular. For large strain plastic deformations, the material model usually consists of a yield function and a hardening relation, optionally including the influence of temperature and strain rate. In large-scale simulations it is favourable to keep the model as simple as possible. The ‘allowable’ error in a material model should be in balance with other errors, like the discretisation error and errors in contact and friction modelling. The required accuracy depends on the application and the goal of the analysis. In many occasions, strain rate and temperature dependency can be ignored, but for warm forming this is clearly not the case. Furthermore, numerical simulation of the onset of necking requires a much better material model than needed for the calculation of the global deformation field before necking.